Пікірлер

• 
  @MikeR-dc8bi3 күн бұрын

  0:41 "aww crap"😂

• 
  @danielcontreras88717 күн бұрын

  My 98 seadoo gsi blow 5 amp fuse every time any help.? Please. No crank. Nothing just blow fuse all time

• 
  @goforcastingsubmission28326 күн бұрын

  Tibbamn, hey you! It's been a while since you've posted... I'm trying to contact you regarding a video you created years ago. Please reach out to me at [email protected] Attn: Mimi

• 
  @kristinakalloff9528Ай бұрын

  Is this starter motor or starter relay that was replaced????

• 
  @1WayfixАй бұрын

  Hello. I have a question. About the starter wiring. Do the yellow and purple wire. Going connect together To the starter signal terminal.??? And the other 2 thicker red wires. To the thick terminal on the starter ??? Thank you. 🙏🙏🙏⬅️⬅️

• 
  @dennisrandall9698Ай бұрын

  Didn’t show how to replace the starter lol.

• 
  @lonestaroutdoorsman96522 ай бұрын

  Save me a buck

• 
  @michellesuzannesebestasebe47013 ай бұрын

  Is that a 1995 Sea-Doo if so, what is your your panel your gauge panel look like and do you what all do you have gas gauge oil gauge speedometer and what are the plugs look like please? Thank you.

• 
  @dbproductreviews63193 ай бұрын

  What a true Rawdogger!!

• 
  @ISaac-yf8kr6 ай бұрын

  where did you get the new fuel lines?

• 
  @jeremyocampo15299 ай бұрын

  Okay now I’m positive it’s my solenoid because when I try to run the jetski by pressing the button it just clicks a lot. But once I jump it it runs the starter.

• 
  @MB-ib7pl9 ай бұрын

  Comical! Don’t do it like this butt plug!

• 
  @norcal87189 ай бұрын

  You have got to be the worst cameraman in the history of KZread 🤦🏻‍♂️ lol But thank you for your time and effort it is very much appreciated.

• 
  @norcal87189 ай бұрын

  Hey did you have a problem with oil in the cylinders?

• 
  @ZachPuich10 ай бұрын

  hi tibbs

• 
  @nathanklein120210 ай бұрын

  i can guarantee it will not start when its on the water. sure it will start out of water but it will def be as compression issue with cylinders. been there done that. this was my first ski. hear mixed reviews on the 657x. mine took a dump on me 3 months after i got it

• 
  @Divinemindset0410 ай бұрын

  man my 2002 Sea-Doo gti is kicking my ass am hopping you can help me a bit! Back story I purchased to skis about two weeks ago never owned any 0 knowledge might have done a few boo boos I those first days of owning them I scared the web and I can say I think Iliana know a lot more now but am still pulling my hair with this sky I can’t get it to start ! When I purchased I didn’t start so obviously it help me to knock the price down it had a low battery at that time and first mistake I use my jump box to starter and still nothing, then I got home and in the next few day I tried to start it with the jumper add starter fluid and it did start for minor periods. Second mistake I didn’t know at that time that I had to start sky then water. Then water off then sky! I was trying to start it with the hose on and then of I was all over the place. Then I learn the cycle and said oh oh 😕 then I decided to buy a new battery because I learn that jumping the unit could damage the computer . So battery came in installed it connected my hose water off cranked it and boom sky fired right up turned the water on and I felt the idle was having issues felt to low so I started reving it a bit it satayed on for about 40 seconds to a minute and all of asl sudden I hear this grinding noice and. Off it goes and I haven’t been able to start it since then I check compression is like 120 both I check spark I see spark I added fuel in the carb and nothing it just cranks and cranks I’m thinking I might damaged the computer with the jump box but it did start once with the new battery?? Am going to put a link to clip that I just took hope you can help thanks kzread.infocibxirPk0Bk?si=tI30I1bY8n8in19-

• 
  @user-kx4dc8fw7r10 ай бұрын

  I have a seadoo gti 96 I put a crossed key in the solenoid and it starts directly without touching the ignition button but it never starts, do you know what happens?

• 
  @JoshM711 ай бұрын

  Funny I just made a BT speaker using nearly the same speaker/drivers. Didn't know I was 4 year late. 😆

• 
  @user-rm7gn2hw6x11 ай бұрын

  OK, I have 92 seadoo sp I thought it was the Silenoid. I replaced the silenoid and the start. It still won't start. I can see the engine move with the click but it won't crank over. Do you have any suggestions?

• 
  @DavidMitchell-zl7ng3 ай бұрын

  either a bad starter or a seized engine

• 
  @albertjanse810911 ай бұрын

  Nice to see you find for every special tool problem a solution! Nice video's! 👍

• 
  @jerrylaundrie795911 ай бұрын

  Just replaced impeller and wear ring, my engine battery dies before can get it to keep running. Starting fluid got it to pop and run momentarily, then dead battery. This impeller must be capilating a lot cus spins fast.

• 
  @geneivebrownmetzger5272 Жыл бұрын

  Very unclear insyructions.

• 
  @Strubsw Жыл бұрын

  What is the ignition controller for an sea do Gyx

• 
  @chaoscobraflashbacks5044 Жыл бұрын

  Would a seized driveshaft cause the engine to not turn over

• 
  @CC-ei2hj Жыл бұрын

  I have a 92 seadoo gts with the 580. I’m also hearing a buzzing when I’m trying to start. From the fuse box. About to try and replace the solenoid. Hopefully that’s it?

• 
  @mrodrigo3864 Жыл бұрын

  Not easy job but it can be done I did bearing ,bellows ,shift cable, out drive ujoint seal,and more a job like that is 2k get the tools makes the job duable anyone with mechanical skills can do it

• 
  @jaganvemula7103 Жыл бұрын

  changed thermal Fuse, however while changing thermal fuse red wire came off from circuit board where does it go(solder)? can anyone guide me thanks in advance

• 
  @carlbathon5459 Жыл бұрын

  Can I add a extra pulley to my

• 
  @marucat2797 Жыл бұрын

  What’s your current favorite adjustable dumbbell atm? Thanks!

• 
  @YouGotItGiyl Жыл бұрын

  I really like powerblocks, close second would be ironmasters

• 
  @beepwhoop3 ай бұрын

  @@YouGotItGiyl How are the powerblock keeping up? People mentioned some urethane models broke on them on the bolted points.

• 
  @nfaproductions83 Жыл бұрын

  Did you finish this boat?????

• 
  @YouGotItGiyl Жыл бұрын

  Yes. I've got videos that I need to upload. Perfect summer time activity I guess.

• 
  @hunterm.172 Жыл бұрын

  I have a 1997 Polaris, SL 700 no spark, but if I press and hold the bilge pump button while starting I’ll have spark any idea what this could be?

• 
  @NATIVEJAYYQuest4sucess17 күн бұрын

  Did you ever figure it out? I’m having the same problem with the same model.

• 
  @hunterm.17217 күн бұрын

  @@NATIVEJAYYQuest4sucess I ended up selling it but I believe the guy I sold it to changed the stator and got it working

• 
  @FKCamVlogs Жыл бұрын

  This video for sure helped me. This was rather one of the very detailed video that I came across on You Tube.

• 
  @pamkaturi Жыл бұрын

  Where do you order the power cord? I have to hold the cord in a certain way to work! Is there a way to tighten it?

• 
  @thomaspaccione8237 Жыл бұрын

  I know this is a couple years old, but those are not Phillips Head Screws, they are JIS, Japan Industry Standard. If you use Phillips on them you will strip the heads. You can tell it is JIS by the small dot stamped into the head of the screw.

• 
  @KryptaKnight Жыл бұрын

  How many cheap DG garden solar path lights will i need to be capable of charging a 12v battery?

• 
  @theking-bh9ph Жыл бұрын

  This guy going to need a new starter when his done.

• 
  @FrankZen Жыл бұрын

  Nice collection! I had the BowFlex 552 but sold them after I got a pair of PowerBlock Sport. The latter felt more like a dumbbell to me on pressing movements. I still have my old spinlocks plus something called Adjustabell that's a handle like a spinlock with flat ends. Similar to the IronMaster.

• 
  @edgardopoinsot629 Жыл бұрын

  Sea doo carburador

• 
  @830jps Жыл бұрын

  ALWAYS pré heat molds before pouring

• 
  @830jps Жыл бұрын

  Hope you are okay

• 
  @830jps Жыл бұрын

  Thanks for this. We all need to see what can go wrong before the try at home

• 
  @crisz9363 Жыл бұрын

  O MY GoD

• 
  @pyrodon1910 Жыл бұрын

  I wonder if the heavier duty bushings setup on the benchpress bar can be purchased and installed on the cheap $20 thrift shop bar also?

• 
  @seymourscagnetti1413 Жыл бұрын

  This shit is so ghetto.

• 
  @Tolderian Жыл бұрын

  AAAHHHH I thought you were gonna use the ego battery with that for a second. That woulda been something lol. So… 3 years later, does it still work or did the battery or speaker burn out from some electrical mismatch? I noticed it hits a higher pitch note when pluggin in the battery vs the wall.

• 
  @AaronS11979 Жыл бұрын

  For anyone watching this, know that this is a CLASSIC low compression situation. It will start (with difficulty) on the trailer, but once in the water it won't. Low compression was likely caused by some sort of lean condition (carb(s) wasn't delivering enough fuel), or the oil injection malfunctioned and the engine wasn't getting lubricated properly. Lean condition causes the motor to run hot (very hot) and that expands the aluminum pistons until they eventually scrape up against the steel piston cylinders and you lose compression. If the oil lines malfunction, the lack of lubrication causes excess friction which also heats up the pistons for the same result. If you have low compression (simple compression gauge test), then you'll have to pull the top end out and replace the cylinders/pistons, or bore out the existing cylinders at a machine shop and get oversized pistons to fit the larger "holes".

• 
  @caroldavies9933 Жыл бұрын

  CRAZY! But I did enjoy it lol

• 
  @byproduct8849 Жыл бұрын

  you call it collection. i call it a bunch of bad buys XD

• 
  @sergiogil118 Жыл бұрын

  Tengo un seed bonbardier. 97. Arrancan bien pero después de 15. Minutos se recalienta un motor y se para.