Пікірлер

• 
  @kriskrepps90125 сағат бұрын

  Mine was the module. Plugged in new one and fired right up. Parts store wanted $450 , I got one on Amazon for $99.

• 
  @iLeaveYouOne-2 күн бұрын

  thank you, my team leader sent me on a goose chase and I looked this video up and helped a lot

• 
  @crazystratcat11 күн бұрын

  Can you repair a factory radio for a jeep compass?

• 
  @robertodiaz163712 күн бұрын

  What if I accidentally unsoldered the chip?

• 
  @user-pj6ci5zp8z22 күн бұрын

  Jeep radio calculation code

• 
  @randallamps22 күн бұрын

  Have a 1991 Jeep Cherokee Laredo with a factory Jeep 56002467(1991) AM/FM Cassette Player and just swapped out the tape modules in two 2467 cases. Now I have me some rocking tunes. Now what I want to know is what is the cause of either the left or right channel going out on a 2467 and on a 56009004(1992) the volume knob is maxed out but I need just a little bit more volume.

• 
  @iamIncrediblehulk28 күн бұрын

  I had the same problem with my 2012 Tundra. It turned out to be a 10amp fuse under the hood that went bad. Replaced fuse, started right up!

• 
  @ukaszguzik213Ай бұрын

  After You removed headup console than issue with bat drain disappeared?

• 
  @user-yc1ig2cz3hАй бұрын

  Only my passenger window will not come up is that a ground wire?

• 
  @cameranmanner4701Ай бұрын

  The water issue doesn't exist with mine. Unless the drain hose is plugged?

• 
  @plouden728Ай бұрын

  Loved your video man. Great help,

• 
  @theamazonsthrower2284Ай бұрын

  Could you change the vin with this 🤔

• 
  @commercialelectrician133Ай бұрын

  Have the same problem with my 2011 f150

• 
  @thatkidinthestripesАй бұрын

  Hey, I appreciate the tips. I actually managed to already know what the root cause of the issue was before I even went into investigating the codes once the drain blockage is taken care of do the indicators turn off on their own eventually or do I basically need to unplug the oxygen sensor and plug it back in like how you did?

• 
  @christianrappastelfaith51982 ай бұрын

  . I have a "IM508S". Today, I couldn't made 2020 Toyota Tacoma all keys lost smart key. Do you think if I have the "IM508" Can I make it? How much did you pay for your IM608?

• 
  @River1Nile2 ай бұрын

  Thanks for sharing. I have a question please. I have 3UZ FE engine with 5-speed auto transmission. It's in a Cressida. I have an immo box that didn't come with the engine ECU. If I program the EEPROM on the immo box, the EEPROM on the engine ECU and the key using the same key code. Would this work? Or is it a must to use the OBD method with the immo box and key to work?

• 
  @catfishsnagger32842 ай бұрын

  Good simple video. We can't see the wiring diagrams though if there is a way to make them easier to see so we can follow along a bit better.

• 
  @micklouie2 ай бұрын

  Do you have to reprogram the vehicle. I was going to replace but people say you need to do this. How to reprogram?

• 
  @claudiuilies92842 ай бұрын

  How can I get a laptop from Isaac?

• 
  @prof.isaganiortiz57192 ай бұрын

  i had the same issue on my toyota avanza, after cleaning sensors, same abs early activation kicks in. could it be a bad abs module?

• 
  @goranstamenkovic29282 ай бұрын

  I got code p0138 wont clear

• 
  @albaseltraining14402 ай бұрын

  Is Autel still working with team viewer ? Is not working anymore . Autel didn't update the TeamViewer so it's not connecting. We emailed them many time and they refuse to cooperate. We told them if would update the team viewer . But no response

• 
  @treboratat3 ай бұрын

  thanks never too old to learn

• 
  @erosmyers3 ай бұрын

  You didn't tell consumer view to fix it. I just had my turn signal flash on immediately turn off while just standing near car . why

• 
  @MountainParameters3 ай бұрын

  Thanks for doing this, I have a 1999 Mercedes ML class that I may have to look for the appropriate EPROM to do this. If you do not have a replacement ECM from the wrecker and want to replace the old EPROM, do you read the file from the old one and then flash it to the new one? Are you also still doing this service at the email in your description? I have a friend who got some solder splash in his eye, and ended up with permanent impaired vision. Now I try to force myself to wear PPE when soldering even if it seems straightforward.

• 
  @Gaspak-bj1rx3 ай бұрын

  Bro literally said it didn’t make a difference with the cat off and still said it’s obvious it needs a new cat… you didn’t fix anything bud

• 
  @TitusHamilton-vc3ez3 ай бұрын

  What do you use to clean board?

• 
  @brangitts87933 ай бұрын

  you can do the same procedure and the same time with im508

• 
  @knock9043 ай бұрын

  I have a black / white wire saying signal ground Is this my ground ..Thanks in advance

• 
  @Rojaktube3 ай бұрын

  I see that you connect the SDL line to the K-Line connector on the GODiag. Is that correct or do you connect that to pin 2 of the OBD2 connector? Or do I need to connect both? How about the ground. Must all the ground be connected on the ECU? If no sensor is connected, will there be communication with ECU? Thanks.

• 
  @barniep3 ай бұрын

  👍 You are very good to explaining things, thumbs up

• 
  @barniep3 ай бұрын

  Hi This virgin file that you have, would that work for a Toyota Aygo? 🤔 Do you have a link to virginice, the ECU's?

• 
  @wayned31373 ай бұрын

  good luch getting paid for that shit 😂 😂

• 
  @tombstone28263 ай бұрын

  Well done ! You look like a pro doing this work !

• 
  @merlepatterson4 ай бұрын

  Considering how many videos are on KZread about this particular problem , Jeep should be mandated to recall these vehicles. I'm currently working on this issue myself.

• 
  @hussainalomran76344 ай бұрын

  Autel does'n accept remot expert applecation

• 
  @OscarHernandez-rj1dl4 ай бұрын

  Great video

• 
  @shawnalrj38874 ай бұрын

  This was so helpful..thank you

• 
  @josel.martinez67004 ай бұрын

  Hi, do you still work on these? I have also a 96 Tacoma 2.4l that needs recap and possible trace repair.

• 
  @troymartin90014 ай бұрын

  I've been working on my daughters 2004 acura tsx. Ecu went bad causing transmission limp code. Grabbed a salvage yard ecu and swapped eeprom's. It runs fine but I have a flashing green key, and code p0603. Any ideas?

• 
  @toanphan9474 ай бұрын

  Can you unlock Toyota ID 4D?

• 
  @user-me6jp5ux1x4 ай бұрын

  Hi did you end up solving the issue with the sensor

• 
  @badlydrawncars64604 ай бұрын

  Watching this with great interest since I've gone through 5 of these radios 💀

• 
  @richardbruno2014 ай бұрын

  Because of that crack, you need a whole new tank? How does that make sense?

• 
  @daviddrennan17594 ай бұрын

  Dude totally awesome man. I'm dealing with the exact issue myself.

• 
  @randykraft24055 ай бұрын

  Its actually the roof rack that leaks

• 
  @bernardaflores17205 ай бұрын

  I believe Honda's AFR is a double pump design. Great explanation of the on the workings but need to include the heater side since they are high temperature requirements for this to work properly.

• 
  @carpenterfamily61985 ай бұрын

  2015 Toyota Sienna STOP Fuse would blow immediately, repeatedly. As others have mentioned we did have a bad / shorted brake light bulb, but in our case the wiring to our trailer hitch was ALSO shorted. Having two problems made it very hard to find ( confusion ) ~ ' just wanted to post this to help the next person.

• 
  @jerryjean30435 ай бұрын

  How to know where the eprom is on the board