I have truly enjoyed your videos. They are informative, concise and very well written. Thank you.

would you please do a video of your air feed? i would like to make one myself and it would be great to see how yours works and was made

@tahoepimp2039 Thanks. Gas checks are needed if you use hot loads. I flux with paraffin wax or Marvelux. Wheel weights are a good lead source for casting bullets. Regards from Germany.

@LongRifle100 Well I build this by my self. All you need is a pressure cylinder with (I think it was) an M30 thread, an hub of 125mm and a threaded end on the hub so you can mount the RCBS internal parts to it. Further I add an pressure regulation device to the cylinder....that's it.

2 years ago you wrote " @daywalker627 Three Years ago I bought this air setup. don't know the specific data but I drive to my shop later and make some mesurements and then I post the data." . . . . and we are still waiting !!!!

@wiederladerTv

10 жыл бұрын

Upps, sorry. There are so much things I have to give answers so I forgot this. Sorry sorry sorry. The thread at the end of the air cylinder is an M30. The stroke lenght is 120mm and the thread at the stroke end is an M10. I don't know if you can find such cylinders with metric thread in the USA.

@daywalker627 Three Years ago I bought this air setup. don't know the specific data but I drive to my shop later and make some mesurements and then I post the data.

Thank you for this comment buddy!

Hmm I think you can seat the gas check this way but maybe it cause some problems beacuse of tilted one on the bullet if not aligned right.

Nice video. Who built the air setup for you? Where can I get one? Is there a piston assembly inside? What kind of pressure are you working with?

The heating plate was not working at this time...so I had to ran the handle three times.

Found these air cylinders pretty cheap on ebay from China and got all excited until I took a closer look. The cylinder blocks the handle from going back all the way and that means you might get away with pistol bullets but the longer rifle bullets simply won't fit with not enough clearance.

@daywalker627 Ok I'am back again. Here are the mesurements of the air set up. OAL = 240 mm, hub = 125 mm, Outside diameter = 34 mm, thread = can't make mesure but I think it's an M30 Hope this would answer your question buddy.

Algorithm Engagement Comment. I have to save such things to get the algorithm to share this video with others!

I have the RCBS LAM I . I am very interested in your air set up. Can we get more information on that please? :) I would like to own a star one of these days. Funding is a bit low.....

On the way...should be online tomorrow

Hi buddy, I'll make a video for you next week, so you can see how it works.

please do.