Thanks for posting. I’ve got to time mine after I changed out the piston and jug and this was very helpful.

Thanks, great job keeping short and to the point.

Thanks, but the problem is getting the chain off past the DRIVE gear with the compression springs tried to remove the big snap ring an cover washer but sprocket won't move any ideals would really appreciate all help, some body else tried to replace chain an now I got there head aches.

Thanks for posting this video. It helped me with the valve timing on my 2015 Hisun 700 - there is little to no consistent info on that machine. Again - Great Job !!

@NNKH2

2 жыл бұрын

No problem! Awesome it helped you out. Thanks

thx for the great quick tutorial on timing !

@NNKH2

7 ай бұрын

No problem!

Great video, thanks, I'm getting ready to do this on my 2007 450 Rhino. Hopefully the timing marks will be in the same location...

Thumbs up 👍

I got a 2012 Kawasaki Trex. Hope it don’t f**k up. Can’t do all that stuff. Great video bud!

this answered the question I had on the gear on the timing gear, book said 3 dots, I could only find 2, thanks

@JakeWork

Ай бұрын

The other dot is covered under one of the clips. Can only see it if you remove them.

Great Video.. Ive done what youve shown in this video but am having trouble adjusting the valves once I put on the valve cover, seems to be too much play in the Rocker Arms to make my adjustments. Any advice? Do you have a video on adjusting the valves? Thanks!

@mricebreaker777

5 ай бұрын

Hello. I have the same problem. Do you fix it?

Thank you for making video it's nice to see different perspectives but the most difficult part of the job, It would have been helpful to see you install the chain over the cam gear? And then place the cam in position? You zipped right by that I wonder why? if you have a brand new chain it is difficult the chain is holding it down, it's difficult to get the cam with the chain on it and get it into the head, you want to be careful and not snap it down push it too hard, where it snaps down, you can scratch the cam or Cam lobes

What was the mile and hours in the rhino when you bought it?

Hey how do you get the chain on the bottom sprocket my sprocket will not slide on the crankshaft.

@NNKH2

3 жыл бұрын

Only way I know of is fishing down there with a long skinny screwdriver or telescoping magnet to finagle it into place

On Amazon: *660 TOP END KIT: amzn.to/2XNyH0g MY OTHER RHINO 660 VIDEOS: ~Purchase/First Time Riding: kzread.info/dash/bejne/n6GX0dGyiLabp5s.html ~Replacing Stator: kzread.info/dash/bejne/pYKntZueldisoMo.html ~Replacing Oil Pump Chain: kzread.info/dash/bejne/mKV_x5OInqafmbQ.html ~Adding A Pull Start: kzread.info/dash/bejne/onprsMd7na-wiKw.html ~How To Set Cam Chain Timing: kzread.info/dash/bejne/i5yCqJNxkbenk6Q.html

Is their a break I procedure for breaking in a new cam ?