Thanks, This info is going to save me $110.00 an hour. You even show us techniqueIts to keep us out of trouble. probably take me a all weekend. But definitely worth the effort. Thanks again. FYI. The coolant thing with the hoses. It does matter. Think of water fall effect if the flow starts at the top. Not the desired effect. Fill from the bottom. The water will fill the hole cooler. Plus the air will purge from the top.

Good video, just finished mine. I like the template for the bolts. I used the gasket cardboard and poked holes where the bolts go. Worked like a charm.

Thank you! Your vid was super helpful! Yes you can remove the stator housing without taking the water pump housing off. I did it and worked fine. As for the electrical connections. Look at the connectors closely, you can take a screw driver, insert it where the plugs join, twist it and connectors pop right off. Thanks again! Gave me a lot more confidence seeing it before I did it. 👍👍😃

Great video!! Thanks for posting. When I did mine a few years back I couldn't find much info online and this would have been extremely helpful. When I pulled my cover off the gears and dowels did fall off, after the initial panic I just used the shop manual to get them all back in place with no problem. A can of gasket remover really helps a lot for getting the old gasket off without causing any damage, well worth the few bucks. Also a few dabs of grease on the new gasket really helps to hold it in place. I figured the root cause of my failure was more than likely caused by using the winch when heavily stuck in the mud and leaving the engine idling so as not to kill the battery, just a guess though. I removed the winch from the main battery and installed a secondary battery under the drivers seat with a battery disconnect switch. I just charge it before riding and keep it completely independent of the Rhino's electrical system and so far so good. By the way, I have the identical C.T. meter, it's pretty decent considering the cost. Cheers!

@mrdiyguy123

3 жыл бұрын

Thank you for taking the time to add such great insight and extra tips!

Great video. Very informative and detailed. Saved me a huge amount of time and effort. Successfully replaced mine.

Great video my friend. Very well explained. Thanks for your help. Cory

thank you so much! great job

What is the detailed manual you are using in the rhino stator change?

The white two wire come into the grey connector from big to small wires do They go a certain way , connected got react not sure witch way the wires go ,, all white any ideas

Thank u so much👍

Does a 2006 yamaha rhino 660 have a crank sensor and if so were is it located?

Thanks.

I also have a 2005 yamaha rhino 660 and I'm having the same issue. There are days when the rhino starts up just fine. then it dont want to start. it has a new battery. when it doesn't start all you hear is a click noise from the relay. is the problem going to be the stator?

@mrdiyguy123

3 жыл бұрын

If it is intermittent it might suggest a dirty ground connection at the battery or fram or elsewhere. Start by checking that first. You need to find out if the "click" is occuring with the starter turning because voltage is too low when trying to start. If voltage always stays more than 12v, the stator and rectifier regulator are not the problem. If it goes below 12v when trying to start you could have: bad/dirty battery terminals or ground to chassis/motor, bad starter, bad wiring, faulty starter solenoid. These things all need to be diagnosed one by one.

If I change the stator on my 2008 Rhino 700, should I change the voltage regulator as well? Thank you for your great video!!! Gave me more confidence to do it myself!

@mrdiyguy123

Жыл бұрын

If you test and prove your stator is faulty, replace the stator. Then reconnect the wires to the rectifier/regulator and start the engine. Quickly test output of the regulator. If you have a fully charged battery , engine running voltage should be between 12.8 to 14.5. If you don't get in that range, suspect a faulty rectifier/regulator.

I have a 2010 hisun utv it's the same as the 2006 yamaha rhino 660 my hisun is a 700 what year is your machine?

What is that tapping/clicking noise after your changes stator?? I just did mine now it has a tapping/clicking noise until it gets warm

@mrdiyguy123

3 жыл бұрын

If you are suggesting there is a new tapping/clicking noise after changing the stator, that would cause me concern. It sounds like a mild interference issue somewhere. I don't recall any such noise after completing this repair.

Is it possible to change the stator without draining and replacing all the fluids or is it a necessary action for preventing spillage? I'm hopeful its not cuz that sounds like a lot more work than id like to do in my front yard 😅 I'm also certain that my stator is bad after watching this video and following the steps. It was super informative and very easy to follow.

I’ve noticed the stator wires in my Rhino are getting pretty hot. Think I’ll check voltages. Might be up for a new stator. 🤷‍♂️

My buddy gave me a massimo 500 and has had troubles with it not charging, how much is a stator and rectifier

@mrdiyguy123

3 жыл бұрын

Not expensive on amazon for aftermarket. Local dealer wanted 4x as much for OEM.

Would that be the same part # for the 08?

@hasanp.7346

4 жыл бұрын

Hola consigue lo 👉Amazon "YXR700F Stator Rhino 700 Yamaha" Buena suerte.

what is the part number for that stator because i have an 09 Yamaha Rhino 700 that wont keep charged?

@eunicep.1441

4 жыл бұрын

YXR700 FI, get it 45 bucks, Good luck.

@hasanp.7346

4 жыл бұрын

@@eunicep.1441That's right....

I’m just curious I ordered my stator from Caltric it was under 60 bucks. Which one did you put in when you replaced yours? Did you go with a higher priced one? they sure look the same as the other ones I’ve seen online just wondering your opinion

@mrdiyguy123

Жыл бұрын

I don't remember the specific model but I know it was the cheapest on Amazon that had more than 20 decent review. 2 years later and no issues.

@anthonypicucci-dt2qf

Жыл бұрын

OK thank you for the reply. Great video very informative.

I have 2003 yamaha kodiak 400 not start, so you can start the and run without stator is working or not correct?

@mrdiyguy123

3 жыл бұрын

The stator has nothing to do with starting or running, only charging

@thaoxiong9859

3 жыл бұрын

Thank you

@JoseRamos-ke2nh

3 жыл бұрын

I also have a 2005 yamaha rhino 660 and I'm having the same issue. There are days when the rhino starts up just fine. then it dont want to start. it has a new battery. when it doesn't start all you hear is a click noise from the relay. is this problem going to be the stator?

@budshoot6951

3 жыл бұрын

@@JoseRamos-ke2nh Not sure if you figured it out but your problem sounds very similar to the issues I'm having with my Rhino and following the trouble shooting steps he described in this video (found on another blog) I was able to confirm it was the stator. In your case, likely either the stator or the voltage regulator (regulator restrictor I think is the name).

Wish you was in ky

Ever had any transmission troubles

@mrdiyguy123

3 жыл бұрын

None