Well how'd we do boys, get her up and running yet?
@Grubbsgarage
Жыл бұрын
Actually we did! I’ve been working super hard on a new project so I haven’t had time to edit the video but it should be coming in the next day or so!
@haydenssmallenginerepair Жыл бұрын
Looks like she is a bit tired but if you bleed the lines she would fire up
@Grubbsgarage
Жыл бұрын
We cracked the lines and they were getting fuel. We nearly drowned it in starting fluid and still didn’t start. How do you bleed the lines?
@joebowser6220
Жыл бұрын
@@Grubbsgaragerack open the fuel lines at the injectors crank it over till you stop seeing foam coming out of the line after you see it cleared up tighten down the injector lines and just crank it over with a little bit of either otherwise you will hydro lock the motor and then your gonna have more work then what you need
@bad122452 Жыл бұрын
Did you bleed the injector lines?
@Grubbsgarage
Жыл бұрын
Didn’t bleed them per say. But we did crack one loose at the injector and it was getting fuel
@bad122452
Жыл бұрын
@@Grubbsgarage Do you have manuals You got to bleed them all
@Grubbsgarage
Жыл бұрын
@@bad122452 I tried looking through the ctm3 manual but didn’t see where to bleed the lines
Пікірлер: 18
She's shot. Time for a rebuild.
What’d u pay for her? I found one for 800 bucks
Well how'd we do boys, get her up and running yet?
@Grubbsgarage
Жыл бұрын
Actually we did! I’ve been working super hard on a new project so I haven’t had time to edit the video but it should be coming in the next day or so!
Looks like she is a bit tired but if you bleed the lines she would fire up
@Grubbsgarage
Жыл бұрын
We cracked the lines and they were getting fuel. We nearly drowned it in starting fluid and still didn’t start. How do you bleed the lines?
@joebowser6220
Жыл бұрын
@@Grubbsgaragerack open the fuel lines at the injectors crank it over till you stop seeing foam coming out of the line after you see it cleared up tighten down the injector lines and just crank it over with a little bit of either otherwise you will hydro lock the motor and then your gonna have more work then what you need
Did you bleed the injector lines?
@Grubbsgarage
Жыл бұрын
Didn’t bleed them per say. But we did crack one loose at the injector and it was getting fuel
@bad122452
Жыл бұрын
@@Grubbsgarage Do you have manuals You got to bleed them all
@Grubbsgarage
Жыл бұрын
@@bad122452 I tried looking through the ctm3 manual but didn’t see where to bleed the lines
@bad122452
Жыл бұрын
@@Grubbsgarage Group 11 page 324
@bad122452
Жыл бұрын
page 332