Toyota Camry Oxygen Sensor Replacement 2007 to 2011 bank 1 sensor 1
Тәжірибелік нұсқаулар және стиль
Oxygen sensor replacement on a 2010 Toyota Camry, Upstream oxygen sensor. Always buy OEM when in doubt.
Replacement oxygen sensor amzn.to/2GYpBHs
Recommended Oxygen sensor socket set
amzn.to/2VP2sLL
Seafoam Spray amzn.to/2D5m6Mh
Dielectric Grease amzn.to/2D5qsTO
Electronic Cleaner amzn.to/2VMdD85
Copper Anti-Sieze amzn.to/2M8dSps\
Great 3/8 Ratchet amzn.to/2M8qBII
A driving cycle is a series of data points representing the speed of a vehicle versus time. Inspection Monitors like the Catalyst inspection monitor need to be complete in order to pass an emission test.
Driving cycles are produced by different countries and organizations to assess the performance of vehicles in various ways, as for example fuel consumption and polluting emissions.
Fuel consumption and emission tests are performed on chassis dynamometers. Tailpipe emissions are collected and measured to indicate the performance of the vehicle.
Another use for driving cycles is in vehicle simulations. More specifically, they are used in propulsion system simulations to predict performance of internal combustion engines, transmissions, electric drive systems, batteries, fuel cell systems, and similar components.
Some driving cycles are derived theoretically, as it is preferred in the European Union, whereas others are direct measurements of a driving pattern deemed representative.
Thanks for your support. God Bless
▶️www.spreadshir...
▶️Support RandonFix visit www.Patreon.com/RandomFix
▶️Support RandomFix via Paypal visit www.PayPal.me/RandomFix
▶️Facebook https: FB.me/RandomFix
▶️www.RandomFIXWorld.com
▶️ My computer for editing/uploading: amzn.to/2CLEx5w
▶️ Video editing software: amzn.to/2z1NvJY
▶️ Thumbnail software: amzn.to/2Bkjw5V
Disclaimer:
Due to factors beyond the control of RandomFix, RandomFix assumes no liability. Affiliate Partner: I'm may receive a fee from some of my affiliate partners for my first-hand recommendations.
related title
how to replace an oxygen sensor on a toyota camry
camry oxygen sensor replacement
corolla oxygen sensor replacement
prius oxygen sensor replacement p1135 bank 1 sensor 1 bank 2 sensor 1
Пікірлер: 36
Cool, this would of been great 2 weeks ago
2:33 Wish you showed how to undo the clip on the upstream sensor, I couldn't figure it out - 2006 Camry
@RANDOMFIX
16 күн бұрын
I show it on this video kzread.info/dash/bejne/h2RhkrqGh7WZn9o.htmlsi=7jV48uwFcldtAUnq
@handyatmusic
16 күн бұрын
@@RANDOMFIX Thanks but on both videos you just say push down, and your hand is in the way. What are you pushing down? Maybe mine's just stuck, I don't want to break it forcing it out.
Good video Thanks.
Thank you. That was a very clear.
@RANDOMFIX
Жыл бұрын
Thank you for your feedback, much apprecated!
I have a toyota camry 2007 and my sensor is on top of the muffler on the front that is bank one sensor 1 is the same thing like the one you working on it.thanks
@RANDOMFIX
2 жыл бұрын
Glad to help. As a smaller KZread Creator, my channel runs on the generosity of viewers like you. ☕️ ☕️☕️Buy Me A Coffee! www.buymeacoffee.com/RandomFix
You put old one back in. ???
@RANDOMFIX
3 жыл бұрын
my o2 sensor was fine, I was cleaning the catalyst via the o2 exhaust port.
In the place where there is no catalyst in the exhaust manifold, will the O2 sensor be working properly?
@RANDOMFIX
7 ай бұрын
Sorry for the late reply, I appreciate your feedback did you get this handled?
Good thank
@RANDOMFIX
3 жыл бұрын
Welcome
NICE VID
@RANDOMFIX
Жыл бұрын
thank you for the feedback!
Dude you got a lot of videos
@RANDOMFIX
5 жыл бұрын
Thank you
How do you take that disk thing off when putting a new 02 sensor?
@RANDOMFIX
6 ай бұрын
I appreciate your feedback Sorry for the late reply, did you get this handled?
@waltersweet4595
5 ай бұрын
It comes with a new “disk”. Look up the Denso air/fuel ratio sensor for this model and you will see they all come with a new heat disk.
Do you need to un plug the battery? Or is it ok to leave it ?
@RANDOMFIX
Жыл бұрын
Sorry for the late reply! did you find a solution?
@katanauwu7200
Жыл бұрын
😂 there’s a plug for it. You can just unplug that…’i think’.
is the anti-seize really necessary?
@RANDOMFIX
Жыл бұрын
Not necessary until it is.
There are two upstream sensors for my 2004 camry 4 cylinder 2.4L. First sensor is Air Fuel Ratio sensor Bank 1 Sensor 1. Second upstream sensor is Oxygen Sensor in Bank 2. Is this video showing air fuel ratio sensor in bank 1? Or oxygen sensor?
@RANDOMFIX
3 жыл бұрын
Upstream bank 1 sensor
@Better_Call_Raul
3 жыл бұрын
@@RANDOMFIX So there are two upstream sensors. One upstream sensor on bank 1 and another upstream sensor on bank 2. This video is showing the upstream bank 1 sensor. If the upstream bank 2 sensor was bad, you would get a different message for that. Correct?
My replacement part doesn't have the shield. Is it neccessary?
@RANDOMFIX
Жыл бұрын
Sorry for the late reply! did you find a solution?
@jessi.drahks
Жыл бұрын
I had the same question . I bought a replacement for my 2007 Camry XLE 3.5 L , Bank 1 sensor 1 replacement doesn’t have a shield . Is it necessary ?
@RANDOMFIX
Жыл бұрын
It’s not necessary but if you there are any wires or or plastic components close by please cover them.
How do yoi know its bad or good
@RANDOMFIX
Ай бұрын
For the upstream o2 sensor, it has the a heater built in that easy to test and for the o2 sensor portion of this same o2 sensor you need to check the live data and analyze it. The down stream o2 sensor has no heater and again you need to check live data on scan tool and analyze it.