Келесі
- 4:52
- 370 М.
- 00:37
- 36 МЛН
- 15 күн бұрын
- 00:33
- 125 МЛН
- 25 күн бұрын
- 01:01
- 3,6 МЛН
- 16 күн бұрын
- 00:39
- 3,6 МЛН
- 3 күн бұрын
- 8:06
- 1,8 МЛН
- 23:56
- 676 М.
- 13:32
- 1,1 МЛН
- 13:17
- 148 М.
- 0:28
- 23 М.
- 7:13
- 649 М.
- 0:13
- 4,1 МЛН
- 1:00
- 780 М.
- 0:51
- 1 МЛН
- 0:33
- 95 М.
Пікірлер: 18
Bought a Sharp washing machine before watching this guy. 😅 Managed to prize the awkward things out although two dropped out the bottom of machine. Video helped .You tube to the rescue again. Thanks for posting. 🎉
@ronenfe
4 ай бұрын
Do you mean they got broken inside?
It was very hard to pull out (Pun intended). But you can actually break off the rubber and yank it with a nose plier or push it in, which causes it to fall down to the bottom, which is open, and thus can be removed.
bro I have the same problem... every video of removing transit bolts I look at, they just pull the fuckers out like nothing and with sharp, I tried straight pulling (like it suggested in the manual) I tried rotating while pulling, I got blue fingers from all the pressure of those white caps digging into them I can't fucking get them out...
Now when I think about it, maybe you should not remove the metal bolts completely, just loosen them and pull them? And then it will get out?
The worst product and company. Impossible to remove. Glad to see I am not going mad.
Bloody demented got three out fourth won’t budge any advice please welcome before I lose my mind
@ronenfe
3 жыл бұрын
Just break it
@ronenfe
4 ай бұрын
Maybe use lube or just loosen the metal bolt half way and pull it.
I found out they are not used as the legs. It just this stupid unclear drawings. The legs are already installed. Use a plier or a screw driver to break those bolts out. Use a lot of force.
@ap0kalyps3
4 ай бұрын
Yeah the drawomg of the legs means you have to Look inside from the bottom to find the broken off piece...
@ronenfe
4 ай бұрын
@@ap0kalyps3 I don't think it is meant to be broken
@ap0kalyps3
4 ай бұрын
@@ronenfe "broken", by twisting hard you Pop of the inside white plastic which falls down I just did it and it's all fine
@ap0kalyps3
4 ай бұрын
@@ronenfe it's still a stupid Design, but I'm pretty Sure that's how it goes since the description tells you to Look under the machine for those parts It's a bit cryptic but makes sense when you considered that
@ronenfe
4 ай бұрын
@@ap0kalyps3 because they should write in words, how hard is it to write? Anyway mine broke but I had to open the top cover to take it out. How did you take it from below? Isn't it blocked?