For the z axis endstops I measured the distance from the base to the lower rod of the x axis

Try the knutwurst Firmware a lot of extra options

@FixTechStuff

2 жыл бұрын

Thanks for the tip! I will check that out.

I use a piece of ptfe tube for the extruded entry, you should measure the distance of the build plate to the base instead to the carrier frame. Reminder to loosen the tension for the extruded turn the screw clockwise . Is your temperature correct. If the nozzle clogs so often something is very wrong

@FixTechStuff

2 жыл бұрын

You mean base as the tray the build plate sits on? The printer is working much better now, although I notice it's still out by 2mm. It must have been way worse than I originally thought. At least 1 nozzle clog was when I was experimenting with ABS, I was removing the ABS and it somehow clogged the bowden tube as well, I had to cut the clogged part off. The temperatures were all wrong in Ultimaker Cura, I believe something changed when updating the software as my first ABS print worked perfectly. I've since increased the temperature by 5c and set the hotbed to 100c and that kind of works but prints still let go if I don't glue them down!

@leontummers3892

2 жыл бұрын

@@FixTechStuff by base I mean the top of the box that holds the electronics. The x axis has to be level For the knutwurst Firmware they have a Facebook group where you can ask questions it’s in German but google translate does miracles if you ask a question in English you also get English answers. For abs an enclosure is advised I rather use petg no harmful odors almost as good as abs

@FixTechStuff

2 жыл бұрын

@@leontummers3892 Very good. Thanks.

Who is Noah Vale and why would anyone try adjusting to him?

@FixTechStuff

5 ай бұрын

😋