Yessss been waiting for an upload from you

@jdmnuggets

2 жыл бұрын

Cheers 😁🍻. Plenty of good stuff to come, thanks for watching

FINALLY - an NZ channel gets recommended to me for a change! Very rate to see NZ channels get recommended to NZ people for honda stuff - you have another sub :) I also put Hasport mounts into my jdm ep3 (70 rating) - and they "bed in" after a few weeks and even more nvh goes away compared to just after they get installed. SUPER happy compared to the worn out factory mounts :) Hasport say that they say they optimise the engine placement with their mounts etc - and yes, it did move the engine a little bit (stuff seems to sit lower now) - and now my car doesn't tramp the tyres when it loses traction any more :) even happier :)

@jdmnuggets

2 жыл бұрын

Hell yeah, cheers for the sub dude appreciate it. Churrr 🍻

I need the part numbers or mount kit number for me to mount an k24 w/automatic trans. Also which ecu and harness did you use?

Bro Greetings from Colombia

Ive had hasports mounts an the vibration is the same as ebay mounts got to break em in i say after good solid 800miles they start to settle in both ebay an hasports

I've run both. And had good luck with off brand ones. But if someone gives me a free set of hasport mounts I'd run them too. All solid mounts have vibration. Cheers on the build update

@jdmnuggets

2 жыл бұрын

I contacted them to see what my options where because the vibration was excessive - above normal solid mounts in my experience, could i replace just the urethanes or just the billet bits etc. They offered to replace my mount kit. So this video would exist regardless of them being epic and supporting me. The issue wasn't just in the grade of urethane it was the rear mount having no adjustability on the angle it mounts to the subframe along with varying tolerances on the side mounts which in my opinion cause the engine to be loaded on one or more of the mounts. Eg there is a reason hasport recommends tightening the mounts counterclockwise from gearbox, rear mount to cam. If you are building a car with a loud af exhaust with preformance being more important than comfort then this likely won't be an issue, in my case im trying to get as close to oem as possible which i doubt is possible with off brand 😁. Thanks for commenting and watching

For the crv k swap you need ek set of mounts right?

Where’s the link to the KO versions 😂

Am i first?

@jdmnuggets

2 жыл бұрын

You are first! 😂

@teamaxlestands

2 жыл бұрын

@@jdmnuggets always the way 😂

@teamaxlestands

2 жыл бұрын

@@jdmnuggets good to see the vibrations are gone but the squeals remain. Hopefully awd soon? :D

@jdmnuggets

2 жыл бұрын

Lol yeah dude, awd and new wheels and tyres this week. Those factory tyres can't hang lol will try it in awd on the stock wheels for a laugh