Thanks so much 🤝🏽

Film everything thing you do to the setup I'm following

Love the content worx..

@oemworx4147

3 жыл бұрын

🙌🏽

Make a video 📹

Film it all we enjoy the content frfr

Have the charge harness available?

Film

Can you show what you did with the old charcoal canister fuel tank vent and where you got your AN fittings? The ANs make it look soooo clean, great videos!

The left side mount did you drill anything

🙌🏾 film everything

Hi i am building a civic ek and i have the same engine mounts.i am going to put k20z4 engine with ep3 gearbox . Can you help me which holes should i put to the engine and which to the gearbox because i hane a little problem with the vct sensor...?

🔫🔫🔫🔫🔫 looked into K to $$$$$$$ just spent $50 on mounts for B18c4 euro swap in ek

Did you use the EK stock subframe?

Great sleeper 🔥

Bro you'r regulator pressure its universal ? Thanks for your videos that's help me a lot

i hate my inovative mounts ive twisted and changed out the rubber a few times im to the point where there not even factory anymore ive braces the passenger mount because i had clearence issues with the vtc sensor

@oemworx4147

3 жыл бұрын

Sounds like you Installed the mounts wrong. There is a k20 setting and a k24 setting.

yes make a detail HOW TO. From where you got the kswap installation parts, motor parts, and alll the modifications needed. Thanks bro

Yes film it please

can you film the video for the 50 degree vtc only. keep up the good work. thanks

Please do a step by step on the 50 degree vtc and type s pump 🙏🏽🙏🏽🙏🏽 it would help me a lot! Great vids btw!

@ZayedGR

3 жыл бұрын

not just u bro😂😂.. it will help us

@duweydang

3 жыл бұрын

The 50 degree vtc has two options. You can machine the non-50 degree gear to 50 degree specs or buy a 50 degree gear and add it. The type s oil pump requires grinding to fit and plug a hole to keep pressure up. There are many tutorials on KZread.

If your doing a type s oil pump ....do u need a vtc cam gear ???

Film everything you do even the 50 degree cam gears

Did you get a big steel washer with your innovate mounts? I was wondering where that goes. Also I have my mounts setup that same way but my rear mount doesn’t line up

So for the k20 I have to use back holes all around on both sides the trans and pass side? I thought it was just to move engine closer or further from firewall

Please film the upgrades

Bro did u able to put in dyno?

Weird the k24 layout is just shifting the setup forward. Would the hood be able to close with the increased deck height on oem hood?

Hell ya allmotor ..get it down to 10s allmotor and show us the recipe

Please film it bro #oemworx

Film it. All content is good content 🔫

film it, yes others have done it but they dont do it well. You seem to keep it to the point.

Film it bro!

Do the video keepgunnin 🔫🔫🔫🔥🔥🔥

About to turbo my k swapped dc2. Keep up with my channel to see if its something you want to do. Keep gunnin.

Film it!