Пікірлер

• 
  @jbug3087 күн бұрын

  Sure wish I would have watched this video first. I dropped the cross bar without any support on the transfer - nothing "fell out", but it sat overnight until I could get back up under it and put it on - then I realized why one side was going on and the other wasn't. Had to get a jack up under it and lift it until it was on. Also, I was totally ignorant that there was another "smaller pan" forward of the larger pan. I didn't drain it. No wonder I didn't get too much out when I drained it. I started filling the large pan and once I got about 3 qts in we started the trooper - kept filling. Once i hit about 5 quarts the fluid started gushing out. I hurried up and put the fill plug back in. Should I have let it drain just a little bit more? Will too much fluid in the tranny be bad? This is a work in progress - haven't taken it for a ride yet - not sure if too much fluid will screw anything up and I'm trying to find an answer.

• 
  @davesmith-ew1iz15 күн бұрын

  I'm removing a center console from a 2002 Ford Expedition for a friend to resale thanks it has a disc exchanger

• 
  @txwing9922 күн бұрын

  Thanks for making this video!

• 
  @insanesmith2212Ай бұрын

  Thank you for saying that what do you expect for a $20 camera I just bought one the night mode is what you pay for it's still a very good camera

• 
  @wtorres5622 ай бұрын

  If you wants to be in charge got to learn how deal with other people working with you.

• 
  @josh_pl4yz3 ай бұрын

  im having the same problem on my 03 where it wont go into the bracket because of the sleeve so im gonna try what you did and hope it works.

• 
  @ryanboytim8963 ай бұрын

  How has your tint held up with the in-channel visors? I've been debating going with tape stick on version because im scared it may make the window "seal" too tight and mess with the tint

• 
  @stahpit19713 ай бұрын

  Guaranteed it will. I spray the window channels with silicone spray keeps everything moving freely and saves the motors

• 
  @mayorhp4 ай бұрын

  Am in the middle of doing this. My question is do you have to remove the flat black duct work under the carpet for the console to sit flush? The flat duct work I speak of I guess takes heat and comes out under the front seats blows towards the back of the cab. Thanks

• 
  @REVNREDMEDIA4 ай бұрын

  No it should still fit as some of the center consoles allow for heat

• 
  @RalphWalton4 ай бұрын

  Q: How will you adjust this grille to accommodate a front camera?

• 
  @pizzasubs4 ай бұрын

  put in a brand new SD car and getting a message on the screen which says NO card would you might be able to help me with this please?

• 
  @REVNREDMEDIA4 ай бұрын

  The SD card may not be compatible try reformatting it

• 
  @pizzasubs4 ай бұрын

  @@REVNREDMEDIA thank you for responding really do appreciate it I think I found out what the problem is I put in a car that's way too big for the camera and I read that it can only take up to a 32 GB card so I'll have to get one of those and try it

• 
  @MonticelloMagic-yv1qu4 ай бұрын

  .. found a 95 iTrooper kinda excited 225 k miles dark forest green with beige interior seller had engine running in the video with pic of odometer they make long running commercial trucks and motors go to 375 k miles under seven hundred so I went for it Looking to hear how yours does down the road Cheers Be Well ...

• 
  @user-lz4vm5lj2k5 ай бұрын

  From Russia with love. Thanks for the video. There are few videos on Isuzu repair on KZread

• 
  @SuperDuty23XL5 ай бұрын

  Great job on the video. Watched another install of different brand and they had them cut the slot in the bumper/tow hook covers as you did.

• 
  @powerbeast56915 ай бұрын

  The tooltopia link does not work anymore. The cheapest I can find for this tool is over $100 on eBay...

• 
  @Zaldi_Txiki6 ай бұрын

  ÒwÓ?

• 
  @nynjanate6 ай бұрын

  No need to mess with the cross member, good video tho... debating on whether i want to mess with the shift shift shaft seal while im in there

• 
  @deanstephens59407 ай бұрын

  I ain't even gonna lie. If I was out and about at night and saw a dude and his ol lady spraying down an SUV with liner, I'd think y'all was tweakin'.......

• 
  @mickvernon28397 ай бұрын

  He has made the job a whole lot harder by undoing the track rod end 🙄

• 
  @santiagomercant92067 ай бұрын

  Thinking on buying a 2000 trooper 3.5 v6 automatic (i assume it has this tranny)(?) Its a one owner 101200 miles. Should i buy it and ad a trans cooler? Will this avoid or prevent the common issue between troopers where the trans stops shifting!? Thank you for your video!

• 
  @miltonloza84287 ай бұрын

  i have to do this in my supercab 2001 F150

• 
  @adamschoemehl8 ай бұрын

  god bless angle grinders right? thx for the video bros

• 
  @user-zv3ix8es2i9 ай бұрын

  Thanks for the video! I did the same thing onmy 98 and it turned out great other then im around 37" in the back and 34" in the front... Do you think I can crank on the torsion bars more to level it out? I went with old man emu springs and rancho 5000x shocks. Thanks for the tip!

• 
  @pat_rick0110 ай бұрын

  Great!

• 
  @joelysuggs10 ай бұрын

  Damn they’re not available

• 
  @juancarloslopezjuarez425711 ай бұрын

  Hola buenas tardes de casualidad tendrán el modelo del retén de la palanca de cambios que reemplazaron?

• 
  @adamwalsh467511 ай бұрын

  Love your videos. So I have a question, I have a 2003 F250, what years of the consoles will fit in it? I have the console with cup holders but wanting the longer console that goes up to the dash. Any inc is much appreciated

• 
  @Umbravenator2168 ай бұрын

  Been looking for my 2002 f250 and from what I can tell a 2002 expedition center console should fit. Going to run to a few junk yards during the weekend to try to find one I’ll let you know how it goes

• 
  @REVNREDMEDIA8 ай бұрын

  @Umbravenator216 thats what I pulled mine out of

• 
  @richardtrowell881211 ай бұрын

  If you don't have a meter and the vehicle cranks you can disconnect the positive battery cable. Be careful not to drop the cable. If car cuts cuts off you have a bad alternator.

• 
  @robertmorris9998 Жыл бұрын

  Great job! I’m guessing you did it at night to avoid peepers lol. And 7 bottles must of been at least 2 coats. It’s been a year how is it holding up?

• 
  @iliveindetroit1 Жыл бұрын

  never seen anyone paint in the dark, but hey..lol

• 
  @pat_rick01 Жыл бұрын

  It is awesome in person!

• 
  @Mr.International82 Жыл бұрын

  I love the idea of raptor lining the body to prevent rust but how much does it decrease your gas mileage by?

• 
  @BAMFSpYdy Жыл бұрын

  Had a transmission leak on my 2001 rodeo, so I did my main transmission pan gasket twice and my shift shaft seal 3 times and then saw where it was actually leaking. Between the 2 pans. Transmission has to come out and be taken apart to fix it. It would be nice to have a lift instead of doing all this on my back in the dirt. I recently bought a 2000 Honda Passport (same vehicle) and it started intermittently shifting funny. So I just did all this to it last weekend. Now it shifts great except for OD. it won't stay in 4th gear once it gets over 50mph. I'm going to try installing new shift solenoids this weekend. Fingers crossed! Spending a small fortune on Transmission fluid.

• 
  @joepena1761 Жыл бұрын

  Thanks for the confidence....it was a super easy task

• 
  @markfreier1287 Жыл бұрын

  Instead of removing the 2 hoses the get the alternator out, I removed one screw that holds the power steering cooling loop--then pushed it aside to get it out. Much easier.

• 
  @pedrobarrios2419 Жыл бұрын

  I have that cd changer

• 
  @pedrobarrios2419 Жыл бұрын

  It works too..I just upgraded to a 2 din Kenwood

• 
  @matthewlewis8605 Жыл бұрын

  Anyone else not able to save their settings? Just defaults on every power up

• 
  @scottdowney4318 Жыл бұрын

  Lifted my 1996 3wd Trooper using Daystar rubber rings. 1.5" in the back. Happy with it. The OEM rubber spring cushion, fit into the Daystar, Pull them out and fit them to the Daystar, then put on the original spring and put into place. Also I lifted both sides same time, Disconnect lower shock. Leave sway bar connected, and you can do both sides same time and tires can stay on. For front, I just turned driver side up 2 turns to even it out side to side, One thing about raising front, you are then running CV joints at a bigger angle.

• 
  @joelysuggs10 ай бұрын

  So you just lifted the back? Got anymore info on it? I just got a trooper lol

• 
  @scottdowney431810 ай бұрын

  Just the back. I have a thread on that a planet Isuzu forum@@joelysuggs

• 
  @allenszykula8071 Жыл бұрын

  Their are definetly easier ways to do this.

• 
  @livefastnoregretgaming Жыл бұрын

  Will this work for a 2002 Isuzu rodeo, I thought about doing just cool spring spacers but would springs be easier?

• 
  @corywilliamsmith Жыл бұрын

  Random question but anyway I can buy or borrow that shift shaft seal tool??😅

• 
  @andromeda2451 Жыл бұрын

  Hey thanks for tutorial. I have a 98 Rodeo here at Baja MX and i had same issue with sleeve shaved to Fit ...(conector plugs are diferente from 98 and 2002).

• 
  @Csilad Жыл бұрын

  Im wondering if a 92 2wd auto trans will mount to a 2000 2wd auto

• 
  @jasonrigsby6190 Жыл бұрын

  Do you get and wind noise from these? Thinking about some for my supercrew.

• 
  @ximist64 Жыл бұрын

  combien de litres de raptor ?

• 
  @georgespangler1517 Жыл бұрын

  I just bought a 98 trooper been sitting for 12 years,, ended up a clogged catalytic converter,,

• 
  @Constantstate Жыл бұрын

  The new console... the shell and core do not need to be separated from each other, just pull the four bolts in the brackets and it comes out in one piece.

• 
  @santiagodavila1426 Жыл бұрын

  You mean the inner shield, the metal brackets the core everything comes OFF as one piece.? Am heading tomorrow to the Yunk yard.

• 
  @owl1873 Жыл бұрын

  The tweaks come out at night, the tweaks come out at night.

• 
  @JW-pj1zd Жыл бұрын

  Does it mess with the camera and sensors????

• 
  @REVNREDMEDIA Жыл бұрын

  No they all function fine

• 
  @bobbywasabii2382 Жыл бұрын

  Hey man I’m interested in a 1998 trooper 3.5L V6 AWD I test drove it and there was nothing wrong I saw no lights pop up brand new battery , tires were in good shape ,the interior was in good condition they outside was in good shape no rust,couple little scratches that aren’t noticeable, well because it has 138,000 on the odometer but it’s really clean man but the only problem I saw was the front window being taped around shut , is it easy to fix the window? And also how is the car on gas now that gas is 3 dollars now? The guy wants $3,000 bucks is this a good price? He also is a Vietnamese guy selling it for his mom and these cars were popular back in the day for them.

• 
  @jeff-yr2wi Жыл бұрын

  will these fit the 2001 trooper and are they stiffer than the old man emu springs? How much lift?

• 
  @REVNREDMEDIA Жыл бұрын

  For springs I would refer to this chart that the isuzu community has put together. They have tried alot of different options and recorded results and if mods were necessary for installation. Old man emu is a great product for both springs and shocks. Give this a read. www.planetisuzoo.com/threads/lift-springs-for-92-02-troopers-and-98-04-rodeos.75761/