Out of all the videos i watched this ones the best thanks guys ❤️

Great job on the video. Watched another install of different brand and they had them cut the slot in the bumper/tow hook covers as you did.

Great video!! Thanks for your help!

With the guard laying flat on the ground you put in 2 bottom bolts 1st then you can pivot the brush guard up to install the top bolts much easier with the bottom bolt holding the weight.

Does your truck have a front camera? Because I see no opening on the brush mask.

My f250 2018 has a front camera , my brush mask is also fully cover but I can still see and use the front camera.

@REVNREDMEDIA

2 жыл бұрын

there is no front camera on this one, but the bar does have a removable square for the front camera.

Q: How will you adjust this grille to accommodate a front camera?

Quick question, I've heard removing the air dam decreases fuel economy. Could you have reinstalled the full dam by cutting slots where the mounts drop down?

@REVNREDMEDIA

2 жыл бұрын

Yes slotting would have worked. We were going for the tremor valance look.

Does it mess with the camera and sensors????

@REVNREDMEDIA

Жыл бұрын

No they all function fine

I was wondering if it messes with the front collision alert system?

@REVNREDMEDIA

2 жыл бұрын

No this brush guard does not block the sensors. Its has activated once since install. This guard even has a removable panel if one had the front facing camera. We like it so far.