X3 F25 Hatch Not Working? Spindle Drive Rear Hatch Open And Close Replacement FULL DIY FC 801709
Автокөліктер мен көлік құралдары
On a BMW the rear hatch automatic open feature can stop working. One of the most common causes of the rear hatch not working on a BMW ( Specifically a BMW X3 G01 ) is the spindle drives.
In this video I go over diagnosis of the spindle drives and full replacement.
This system is also known as the HKL. I go over the location of the HKL module and some common things to check, such as water intrusion.
Fault Code 801709 Rear Lid Lift Motor Left Open Circuit.
This video will also help with removal of the rear trim panels, Side trim panels, C pillar removal and much more.
Пікірлер: 9
Nice video. Nice instructions. This procedure should be similar For an F15 X5. Keep the Bemmer videos coming. greetings from the Old Jarhead in WNC
Ummmm, that isn't a G01. Since you're so familiar with the brand, you make it look easy to do. Nice video.
@AskTheCarExperts
3 ай бұрын
LOL F25!!!
Hi what model is the aural diagnostic system you are using please. Great video I have ordered two replacement spindle drives and need the aural to check the codes etc. also have parking sensor issues as two have been pushed in from the bumper. Thanks again for the video very helpful information
@AskTheCarExperts
24 күн бұрын
MaxiCOM MK808BT Pro. My friend just purchased the expensive one with programming. I want to check that one out! I hope the spindle drives do the trick for you!
Thank you so much for this video. I feel like I'm slowly getting to the point where I can fix a similar issue in my car. After replacing a submerged module with a matching used one.. My Autel scanner doesn't even recognize it. Do you know If it has to be programmed to even be seen my a scanning software?. I would think that a matching one should at least be visible in the module tree Thank you so much in advance
@AskTheCarExperts
Ай бұрын
Glad to help. Sorry you have an issue with water damage. The autel should see the module. The reason it cannot is usually due to a wiring issue like power ground or communication. Using the same matching module should allow the scanner to see it even if it is not programmed.
I really like your videos, thanks for all your knowledge. What state are u located in ? I need help with my bmw
@AskTheCarExperts
3 ай бұрын
Hello, Thank you! I am in the East Coast area.