VERY NICEJOB WELL DONE . 💯💯💯💯💯

Thanks, I might do the same. The max current I would have would be 50 amps, it seems that 2/0 wire would be overkill in my setup.

@blueskyadventures759

Жыл бұрын

2/0 would be overkill for only pulling 50 amps. Even when I plan on pulling 120 to 150 amps, 2/0 is over kill but I wanted to minimize voltage drop. I hope it still helps you with an idea of how to run your wires through the cab area to get to your DC-DC charger.

There is a battery aux wires on the right pillar

@blueskyadventures759

6 ай бұрын

The upfitter connection in the right b-pillar is limited on its current output. It is fused for 70 amps.

A 4awg will do the job

@blueskyadventures759

8 күн бұрын

2/0 wire is certainly oversized. I wanted to minimize voltage drop and allow for 120 amps to be pulled. I agree 4 awg would certainly do the job. Thanks for the comment!

Your connection is not fused. The cable should be hooked up on the opposite side

@blueskyadventures759

6 ай бұрын

The video angle may make it difficult to see the fuse and how the connect is made. The connection is certainly fused, watch this video for a better look at the properly fused connection. kzread.info/dash/bejne/rGWFlJOlace2o7A.htmlsi=3w1NoHzh8KLBRWAo

Can you send me your battery bank.

@blueskyadventures759

Жыл бұрын

I have 5 100 ah heated battle born batteries.