VRod Engine Coolant Temperature (ECT) Sensor Replacement

Replacement of VRod engine coolant temperature sensor on my 2006 Night Rod VRSCD. I did not drain coolant, so I leaked a fair bit onto the drive way! This does not involve removing the water pump, and requires a 19mm deep socket (sparkplug socket works fine) and extension.

Пікірлер: 3

  • @cy9her
    @cy9her Жыл бұрын

    Hi, I watched your video because I'm looking for an answer to a similar situation. I just bought a 2003 V Rod, I saw that the coolant tank was empty, I already sent to buy the liquid, and here comes the question, when you turn on your bike, the fans that are in the radiator, are turned on at the time or how long it takes, I imagine that this is the temperature sensor, to activate them, right? And if so, I did not notice where it should be located and how you worked to remove it and place it back.

  • @41BeachComber
    @41BeachComber2 жыл бұрын

    What fid you use to read the codes and clear them too? I know cars have a OBD2 Port to hook up too, not sure on bikes.

  • @enriquepalacios8309

    @enriquepalacios8309

    2 жыл бұрын

    To read the codes, 1- Ignition off 2- push odometer reset button in & hold. Make sure run switch is on. 3- turn ignition to run and release button (you will see P, S &C displayed) 4- each letter represents an area of diagnostics... the one that is flashing is the one you are going to check. To move from one letter to the next, you push the button one time. (from P to S to C and back to P, etc.)