Hey on your stator puller build tension with it then smack the flywheel with a rubber mallet it’ll pop right off

excuse me a question because when I remove the lid it has too much oil

@JakeMMelvin

Жыл бұрын

What lid?

Thanks for showing how to hook the wires up. Useless

Were did you buy any chance get the part from what website

@JakeMMelvin

2 жыл бұрын

What parts?

@braxton6453

2 жыл бұрын

@@JakeMMelvin I was asking were did you buy that stator from

@JakeMMelvin

2 жыл бұрын

Link in the description. It is the correct one. If you look at it, it has the longer yellow wires that are needed to reach the regulator. The other ones that are listed have all the wires the same length and won’t work.

And the secret to removing the flywheel will remain a mystery?

@JakeMMelvin

Жыл бұрын

Keep tension on the flywheel puller and tap the outside of the flywheel with a soft mallet. It will eventually come loose. They are a bear to get off the first time. Once you’ve had it off a couple of times, it comes off much easier.

@jsimm4587

Жыл бұрын

His puller was inside out had the bolts pulling threw the curved slots . Put some pressure on it hit it with a hammer tighten the puller little by little after hitting with a hammer unless turning it is hard . Don’t draw back to Hawaii and hit it just hit it a little then try to tighteng the puller .

the earth wire that you just pushed back is going to rub through the spinning flywheel should of been tucked behind the stator and tied. DOH

Was this having a rough mid throttle

@JakeMMelvin

3 жыл бұрын

Nope. It would not idle more than 10 seconds. It was like someone just turned the key off.

@smokeybandit4910

3 жыл бұрын

@@JakeMMelvin There's a video about a kill switch, they go bad and you can unplug them and check for spark that may be the problem

@luisitodiaz2650

3 жыл бұрын

I'm getting only 1 spark right when I hit the start button. Might be this my issue? I have a new coil. New cdi.

@JakeMMelvin

3 жыл бұрын

@@luisitodiaz2650 Did you check the gap on the pick up?

@chilipepperpepper6488

2 жыл бұрын

Having an issue on my Polaris Magnum 425 will not take full throttle after riding it for a few days I parked it, went to go fire it up will not start I have gas and Spark shot some starting fluid in the carb still will not fire up couple ignition pops that's about it Any ideas since yours is kind of doing the same thing?

When tr guy ing to start it

@JakeMMelvin

2 жыл бұрын

I have not. I am selling it.

I have one fu his like yours and all it does is click