I love watching your videos!

Keep it up with the awesome videos🤟

@pineconewhisper

5 жыл бұрын

Cort on The cob I eat pears now

I love your videos i watch them instantly when you uplode them

@danielsmith6079

5 жыл бұрын

Same he is my fav you tuber f ninga

@hairyballs9007

5 жыл бұрын

Same

@brougay7504

5 жыл бұрын

Kinda gay

@looxys4550

4 жыл бұрын

@@danielsmith6079 hey dainel

@looxys4550

4 жыл бұрын

@@brougay7504 how was that gay if u watch his visa when he uploads like dude shutup u worthless piece of garbage

Love the vids man

Vids are sick. Keep it up

Keep up the good vids dude

I love your videos I instant clicked

Nice vid keep it up 💪

I would definitely try lubricating the cables going to the throttle. That could be causing your high revving throttle stick issue.

This was my first quad.....it was great

Love the vids

The breeze was my first four-wheeler back in 1992 it was a Christmas gift. It dropped a valve and ate the piston up. If you hear a unusual noise stop running the four-wheeler and get it checked out.

Beast

Every thing you own you think the float gets stuck lol I don’t seem to have that problem very often

@PhilBender612

5 жыл бұрын

If he takes apart all the carbs and the float still sticks,? He doesn't know what hes doing. Still learning I guess.

@jojostorm

5 жыл бұрын

In every video he says the float us stuck lmao

@shirleyjohns1798

5 жыл бұрын

What hapund to finger

@mondude9754

2 жыл бұрын

Yeah but eventually a carb goes bad and it will leak gas indefinitely

Check the position of the mixture screw and as suggested bellow lube the throttle cable and check for vacuum leaks

I'd take the carb completely off and give it a good clean again. Make sure the throttle slide moves freely inside the carb and give the rubber boots a good check over for leaks. 🤞

Yessss boyyyy

yay

Definitely seems lean like there could be an air leak try spraying some starter fluid around the air intake and manifold and if rpms change at all theres a leak

@legion3308

3 жыл бұрын

It is a breeze. I know a bad pun

Could be the throttle cable, or the carb throttle slide could be gummed up from sitting.

That thing sweet too

Keep it up

Good video bro.

Yo that’s awesome I have the same quad

Nice vid

Nice bro

Hey migs when's the video on the supermoto bike coming out please do it soon and keep it up

Finally!!

You just got a new subscriber

Love your videos and learn from em. But can you make videos more often? :) Pleasee

Live ur vids man

@marksanchez857

5 жыл бұрын

Love***

Typically rev hanging is from a lean mixture or a vacuum leak. However, you would usually here backfiring when letting off gas if its from a lean running condition. Id recommend making sure the pilot screw is correct and if that doesn't help make sure the slide inside the carb is not getting hung up at all and that the cable is lubed.

Your a vehicle scientist

Do more quad videos they are very helpful and to you to as you can see it brings views for you please more quad videos Thanks.

You should totally make a video of all your machines that you have

Vacuum leak if it's revving weirdly

@bellndben.6952

5 жыл бұрын

Bike Stream maybe if it did it by itself yes but its the throttle sticking if it stays at high rpm after revving it

@johnnickle4843

5 жыл бұрын

Not always vacuumed could be a float seal or air fuel

@ramrodskip518_7

5 жыл бұрын

Could also be running super lean

FINALLY

upload more vids your awesome dude I just got a new quad it is a Polaris magnum 425 it's a 98 that has not been started in 20 years no lie they used to go hunting and he has not used it in 20 years no running or anything. we got a new carb and now it# runs and rides. we dragged it out of the yard because the steering was locked so he gave us the keys and we tried for at least an hour and finally, it unlocked and my dad towed it with his truck and got it on the trailer.# runs and rides

Big fan and I also own a Yamaha Breeze

@EGCNite

Ай бұрын

Nah

you could try lubing the thottle because it might be sticking also if the cable is routed wrong it can put strain on the cable and stop it returning properly

Yes First Nice vid

There’s a air leak somewhere. That’s what causes it to rev up and hang idle. It will also do that if it is lean

the revving up problem is typical of a clogged pilot jet. you had to raise the idle really high to get some fuel from the main jet to be able to idle, so it is running lean at mid rpm and good at high rpm. the result is a big lag from idle to mid rev. check your jet and air passage. it might be an aire leack too, paray some carb cleaner on the carb and intake boot at idle, if the engine rev up you have an air leak. It can be a float high adjustment too, specially after pulling it that hard

Lower the idle. Then tighten up the throttle cable tensioner some . 👍

Hey migs you inspired me to get a quad that didn't run but I fixed it by only watching your vids

@noahlangrehr597

5 жыл бұрын

Lies

Maybe the needle assembly that is connected to the throttle cable is slow and that is why it takes a while to go back up to idle. The needle is connected to the throttle cable, therefore when you push the throttle in the needle lifts up, letting gas go through into the carb. You may check that.

4:30 looking to see if anyone saw him 😂 😂

@bowsonbows1370

5 жыл бұрын

Ayo fatty I'm tryna ride wit yo and yo brother

@jacko3841

5 жыл бұрын

@@bowsonbows1370 dm me on insta bro

@_j.1s__152

5 жыл бұрын

yo fatty love from the uk bro insta @j.ones

@ocke056

5 жыл бұрын

@@_j.1s__152 it s not the real fatty i know he s channel

My Yamaha bigbear revved our and the carbourator manifold had a whole in it

Love your vids watching all your vids

I had this quad! It was a 69 I believe. It ran great until it finally died a few years ago. Im 14 BTW and I have a Honda Recon Now. 👍 Great Video 😁

@tommyfinn4432

Жыл бұрын

It was a 69??

@flowerman4861

Жыл бұрын

I got one as well I believe it’s from the 2000s and it has issues starting after a long time of not starting

Looks like your adjusting your idle/air mixture..you need to adjust the screw on the thumb throttle if there's not one there then on the carb there's a screw on the butterfly that you adjust to keep it idling...the weird revving is because you messed with the idle air mixture screw... screw that screw all the way back in then unscrew it 2 turns and that will put it back to stock

you should do a video of all your projects

I got a Yamaha Two it’s been sitting for seven years it just needed a new battery

I have the same Quad! You have To ride a lot then it wil be beter. I wachted out of the Netherlands😜

I have the same quad and int run always if its cold no problem is it hot no probel mits a mice quas

Always always always start with tirely clean fuel system!

I have a breeze too and it does that

Mine use to do that so my dad thought it was the carb so he brought a new one then it still had the problem and I found out it was just a leak in the fuel pipe

Hey buys Briggs here

my yamaha breeze has a long rev too

Just future advice when working on something that seat up drain the tank clean the tank before but that gas to the freshly cleaned carb

Air leak ore, the needle clip timing ore it also could be the valves

Either vacuum leak, sticky throttle cable, or carb adjustment. Iv have a 89 breeze and never had a problem like that

It might be getting a little hung up in the housing or it also could be the slide in the Carburetor

Have the same thing and I don’t know how much it would be for you to send it out on the trak

i had the same throttle problem on my gs 750 and all it was, was the idle was too high and it also set for 7 years but i turned down the idle and it fixed it self out

I used to own a breeze same color that he has but mine blew up sadly but now I have a Yamaha wolverine 350

I used to have a 2004 yamaha raptor 350 and i had that problem of where it revs too much after giving it gas, I rebuild the carb and then ran perfect, i think u need a carb rebuild like me

I thinks it the throttle cable had the same problem on my banshee 350

You have got to drive it

Try your rich and lean fuel mixture screw.

noice

Make sure the air box is tightened down all the way

@chrisfarren5839

5 жыл бұрын

Or clean the carb again since it still had bad gas in it the jets are probably clogged

It’s doing the same thing as my Kawasaki Bayou 220 when you adjust the idle screw it controls how high that rev. Is when you push on the throttle for some reason it doesn’t actually control the idle

Yeet notification squad wya?

I have the same quad

try adjusting the mixture screw

Throttle cable could be frayed and keeping the rpm high

I have a grizzly Yamaha 125 it does the same thing don’t worry about it.

@nou943

5 жыл бұрын

well you clearly dont give two shits about that quad

@reidmiller4626

5 жыл бұрын

no u there is no need to be rude like that and so take very good care of it but I don’t always have time to ride it because I live in town and it is out at my grandmas farm. So please stop being so rude.

back the idle screw all the way out mine did thhe same thing

I have one to

@12:27 when she gets you a quad instead of a dirt bike 😂

@madmachines7427

3 жыл бұрын

some people like quads more (no hate)

Eyy

It will rev and drive on it's own when you leave the choke on

Where do u buy your parts at please let me know plz i be so thankful

Uts a yamaha thing when they sit there fir a while they wont idle for a while abd the throttle is insanely touchy it fixed itself on both of my blasters they sat for like 10 years put marvel mystery oil in it it will help alot

Hey it revvs out because the throttle line is fraying in the rubber so you need a new cable

And yes breezes stay on higher rpm when u let off. They r gun but they can stop running easily

Had the same problem with my Yamaha grizzly the throttle cable was rusted and when I reved that up it would stay there but then the vibrations of the engine would not get back down to an idol so I had to get a new throttle cable And WD-40 would not help and I was also pretty closely exhaust is loose the exhaust fan so I was pretty close to it

Try adjusting the air screw

Dude I have a Yamaha Grizzly 125 automatic it looks the same as your engine wise and it does the same thing it’s a factory thing. Trust me there is no problem.

Vacuum leak or sticky throttle cable

i put my Breeze through hell for almost 16 years and it ran great still after i sold it hah things are tough as nails

@_yerc

3 жыл бұрын

They sound different on video

Migs put that engine on the nascar. Drive. Natural. Reverse. Mod the engine up a bit

@johnniereyes643

4 жыл бұрын

Are you crazy the nascart has a way bigger motor

@ricerneon399

4 жыл бұрын

@@johnniereyes643the cart that's still not done and an 750 that's gonna jump out of the frame as soon as it runs right and makes power

@johnniereyes643

4 жыл бұрын

@@ricerneon399 shit I haven't seen that one yet I'm gonna check it out

My grandmas breeze had a throttle then die problem. Heres what it is. A fuel line has a leak or the carb isnr delivering enough gas

vacuum leak check gaskets and manifold and intake

what was the size of the tire you put on the supermoto

Do a banshee build

It's the screw next to the idle

I had a 1998 Kawasaki bayou and it did that gas thing