This js happened to me and same exact noise and all I did was tighten my swing arm and it went away hope this helps someone 🙏

Ether tighten your chain or the bearings need replacing because your chain was too tight

Geezus these comments show most of u dont own a surron and dont know a damn thing lmao

Tighten chain/belt

Tighten sprocket nut on motor or check your bearings in midshaft or back wheel

It’s the belt it’s slipping get a new belt or get a chain

Mine had the same! chain was way too loose, tightened the chain and it went straight away

Sounds like chain may be too tight

Prolly the chain is too tight or the belt drive is too loose. There could be debris to a good clean of both of those machinery parts. And make sure not to over tighten them could cause stress that leaves noises like that 👍

I have a STACYC doing this

Mine has the same noise but I let go of the throttle and slow down

i used to have the same issue with my bike, but the noise went away when i changed my chain

Your belt broke

Belt is loose

Make the chain tighter

How do u fix this problem???

How do u fix this problem

Can this brake your bike ?

It’s either A belt tension is either to lose or to tight B Jackshaft bearings bad or C which I highly doubt cause the belt would just slip, or break knobs on belt worm down.

@Jack-bx9tn

7 ай бұрын

Could a worn down belt make that noise??

My sur ron got the same noise, did you fixed already?

need a jew jack shaft

@standeman32

9 ай бұрын

Yea I got this same problem, just ordered a new Jackshaft and titanium swingarm bolt. Haven’t torn it down yet, but based on all the videos, these are all what a damaged jackshaft sound like.

What is this issue my belt is loose enough but not to loose and sounds like it coming from jackshaft not rear wheel can someone help me with this problem

@813jake

3 ай бұрын

Hey I’m having the same problem and these comments are no help did you figure out the problem?

@Kraffti87

Ай бұрын

It's a bearing if it the wheel then it's the jackshaft I had same noise on my talaria went away when I changed wheel bearing

Ur belts stripped

jackshaft bearings

Loose belt

I had the same noise i just loosing my belt and the noise is gone. Hope this helps for you

@jasonstewart3748

2 жыл бұрын

Nah, its still there. Jackshaft bearings are $18. Im going to tap a grease zerk into the jackshaft to see if it extends the life. While I'm in there im swapping the belt primary to a chain. With the squeaky dry belt after a year my bets are on the 212 chain drive being quieter in the long run.

@CryptoDailyHQ

Жыл бұрын

@@jasonstewart3748 i had the same problem i bought a chain conversion kit yesterday

Did you fix it?

@jimmyknopfi5668

3 жыл бұрын

loosing the chain was working for me

i know what is causing this noise.

@krispewkrem3

3 жыл бұрын

Chain too tight? Motor mount creaking? Mine does the same and I haven’t figured it out.

@69NOMAN69

3 жыл бұрын

@@krispewkrem3 have you tightened your swing arm? if you tightened it up and it stops only to return after a ride or 2 let me know. but more than likely its your main belt is to tight.

@donsurron76

3 жыл бұрын

@@krispewkrem3 belt to tight i had the same issue

@hamzahmushtaq877

2 жыл бұрын

If there's creaking when you mount and dismount just looked the bold to your rear suspension linkage

@REVENNARAS101

Жыл бұрын

@@hamzahmushtaq877 mine creaks while mounting and dismounting, what is the fix for the problem ?

It’s the brake caliper hitting the spoke

How do u fix this problem