Love the channel and content! Shout out to your dad for bringing you up with cars and teaching you the ways! 😎

Thanks for the video brother

Done.. no big deal.. everyone els under the sun makes 2,3 and 4 part videos... Thanks, quick and easy not everyone has 3 hours to see about one small thing... U did it in 15min. Thanks-

@FacesintheStone

7 ай бұрын

I’ve been studying the quadjet for a few weeks now. It does take a minute to wrap our head around it.

Thanks.that brought back good memories.my first rebuilt was a quad on a 87 elcamino 350. Was my dads car.got my licence and he said he will give me the keys to it if i got it running. All that was wrong was the accelerator pump.

Awesome video thank you for the attachments on the adjustment and diagrams.

@BurnoutsAndRotorblades

2 жыл бұрын

Glad it was helpful!

Great video! I would like to find one of those Aneroid cup spacers? Mine came off a 1987 350 but did not have one of those in it.

Appreciate the video!!!! My only concern is.... you made it look so easy. Im gonna attempt it on my 78 corvette.

@BurnoutsAndRotorblades

7 ай бұрын

All things are possible through editing. The rebuild was easy though. It’s the setup that takes time.

The accelerator rod was originally connected to the hole closer to the pivot on the pump arm, but when you reassembled the carb, you connected it to the second hole. Did you notice any change in throttle response/drivability/gas mileage?

Your power piston is all bent up! 😅 7:51 when your rebuilding you want to make sure that that is all level. ❤

Will you rebuild my 1986 Quadrajet? Please!

@BurnoutsAndRotorblades

2 күн бұрын

The video is to show you how to do it and the resources you'll need. There are rebuilders out there, but I'm not one of them. Thank you for the vote of confidence, though I will admit editing can make anyone look like they know what they're doing. If I can do it, you can too. Good luck.

very good video! I need some advice on something. I recently bought an 1986 chevy truck with a V6 4.3. It has a propane system on it and the original carburetor is no where to be found. I have a 78 quadrajet that I just rebuilt and would like to install it. the truck intake manifold is the original spreadbore quadrajet carburetor. Also this engine has the electronic spark control distributor without the vaccum advance. if I put this 78 carb I got on it do you think it will work just fine?

@BurnoutsAndRotorblades

Жыл бұрын

I don't know much about the conversion but it doesn't seem to be very complicated. I don't see the harm in trying. However, the propane system seems very interesting. Any reason in particular you're trying go convert back?

I'm going through the same process, my new carb gasket does not separate the primary's from the secondary's, does that matter?

@BurnoutsAndRotorblades

Жыл бұрын

If the old one did I would double check the carb kit compatibility against the carb's part numbner.

I rebuilt mine due to a no start issue, car fired right up and ran, once it got hot it wouldn’t start again and still not able to get it to start even cold now….any ideas???

@BurnoutsAndRotorblades

Жыл бұрын

Hard to diagnose on the computer. did you squirt some fuel in the intake to make sure it's a fuel problem?

Trying to find one on Ebay for my C10 but they all look like total junk. Gonna have to buy 5 of them to make 1.

@BurnoutsAndRotorblades

Жыл бұрын

That is the way it is sometimes. That's why old timers have stockpiles.