Thanks for not talking at all. Very informative

Ours makes some sort of noise when we are in low gear when accelerating for a while it makes the sound but in high gear it’s only 15 or 5 seconds

Mine is a kubota in a microcar and something it sounds like gearbox in a manual when you dont fully dip the clutch to shift and it grinds at and wontngo past 35 mph ???

Did you ever figure out what happened to the transmission?

I ended up just replacing the whole transmission with another used one. We opened the replacement tranny, to find out that the big fly wheel that wiggles in the video. Isn't suppose to do that. It had wear marks on the teeth too, from rubbing up against the other gear.

I'm really starting to think Polaris is trash everytime I turn around between me and my buddies there is always so many different problems

What's the fix?

That first thing u wiggle is a problem in many Polaris ATV. Just bought a brand new one today. And you can hear that clank every time I hit throttle and let off

@stevey500

7 жыл бұрын

What's the actual problem? Is it something not assembled properly and correctable DIY by the owner? What's all involved? I have a '16 sportsman 570 with 39 miles that makes a clanking noise when letting off the throttle going down hill.

@blakec8082

7 жыл бұрын

Just bought brand new 17 and it does the same

@jockiboy

6 жыл бұрын

Got a 17 570 and it has this clank. Read everywhere that it slack in the drive train and normal. Annoying as hell and sounds like something is about to break but i guess its safe..

@nickdelaigle2166

5 жыл бұрын

I have a 00 trail boss 325 it makes a clanking sound when I slow down.. I hope it's just a polaris thing and nothing breaks

My 99 polaris 500, all of a sudden has no forward or reverse, when i move selector it moves freely, something came loose or broke inside the gear case, happened all of a sudden, anyone know what happened ?

And grindw if i try reving at a decent speed up a hill

Is this the throttle clunk sound when you go fwd or reverse. Even when u come off the throttle. Is this the sound?

@robinson1toby

6 жыл бұрын

Deerector, no not a clunk sound. The sound I was getting was the gear teeth grinding and causing a high pitched rubbing noise. From the rear end.

@Deerector

6 жыл бұрын

Toby Robinson yup. I saw part 1 and heard it. Thanks.

@kevywilliams3304

4 жыл бұрын

That is all normal it’s the clutch spring tension and the belt flapping

I have a 96 Polaris xplorer 300 it grinds in reverse I can't seem to find anybody that can tell me anything about it is there anyone that can help with some information on what would cause this

@donnyovercast3559

4 жыл бұрын

See if it has a "silent chain". Its a reverse chain. My sportsman was grinding in reverse. The silent chain was stretched. The only thing that chain does is work reverse gear.

@BrandonBigB956

4 жыл бұрын

The xplorer uses a silent chain. It actually is used in forward and reverse on this model. They always start making popping or grinding noises in reverse first then get where they do it in forward also. Actually replaced a silent chain in a Xplorer 400L last week. You can get part numbers from Cheapcycleparts.com and order parts from Ebay, Amazon or straight from Cheapcycleparts.com. They have the full microfische of the machine available. The Xplorer 300 and 400 use the exact same transmission with a 34 link chain. Run 10w40 motor oil once you rebuild the transmission not gear oil. Gear oil is too thick which causes it to sling off the chain and it stretches because of pin wear from no oil.

@marte1a256

Жыл бұрын

@@BrandonBigB956 does this silent chain exist on a predator 500? I replace chain sprockets and drive belt and still can only crawl a little bit with no power and a crazy grinding sound coming from somewhere

Mine has the exact same problem

@shawncustom

8 ай бұрын

Just pulled it all appart and put it back on. No more play. It wasn't seated all the way down the shaft. The snap ring groove is to far away, the ring doesn't hold it close enough and let's it slip off the shaft