A bad control unit ever occurred to me - don't know if my mower has one but if it does, I think you may have just revealed why I have no spark with a good coil and spark plug. Many thanks in advance!

@Brandondood

9 ай бұрын

hope this helps! good luck

Good info! Thanks.

@Brandondood

Жыл бұрын

Thanks for stopping by and leaving great comments! I really appreciate it

Do you have a part number for the modual or Amazon link?

@Brandondood

11 ай бұрын

Hello. I used a X002YSRU1J From Amazon ZhongfaTec. I think it is a replacement for the BM11 Module Ignitor. Maybe search bm11 igniter and see what is available

Why do we need a flywheel brake??

@Brandondood

9 ай бұрын

Yes on the models with no blade brake clutch. If direct drive there is no electrical shut off on the control lever and letting off of the safety cuts power and also applies flywheel brake

I would like to see how to get all the plastic covering off the top of the engine. I can't figure out how to loosen the one big nut in the top center above the flywheel?

@Brandondood

11 ай бұрын

there is a great trick i use on difficult flywheel nuts. take the spark plug out, use a long screw driver to touch the top of the piston and rotate the flywheel until the piston is away from the hole. now there is room in the cylendar. I feed a section of rope into the hole, never letting the end go inside so it can be pulled out. with some rope inside, rotate the flywheel left (ccw) until it stops agains the rope in the cylendar. now you can use a wrench to loosen the flywheel nut. or another method, use a impact gun on the nut and it should not rotate the engine much to loosen the nut. or even have someone with gloves hold the blade steady while you try to loosen the nut. be safe. always remove the spark plug boot when rotating the engine. hope this helps!