Hey Todd I'm glad your doing this just like Rex Welch R.I.P I enjoyed watching his video aswell

Love it I have this motor in my supermaxx

You can use the drive shaft from the drive train cut the one end off from a savage hpi dog bone if you need to and use a drill because the shaft is round not hex but in a time of need it works 👍👌✌️💯🍻

You, sir, are on point. I do the same if I can make my own. Why buy it😁

Nice detailed over view of the mach 26 mine only has one shim from the factory and its copper 0.16mm whats the difference in having 0.45mm shims in engine performance

I'm a really big fan of the .26 in the monster trucks they behave allot better than ur bigger cubic engines in my opinion first mod I do to my old .26 is put a hpi f4.6 carb on them stock mach crb like u said being al aluminum the slides ware out from the heat ND restart problems f4.6 carb problem solved

@wesdex04

Жыл бұрын

Some of the early release m26 and m26ss came with a hard anodized slide in the carb. I have a couple they run great with very consistent idle. The losi 350 also came with a very similar carb with anodized slide.

@samsonight2721

Жыл бұрын

Yes that's right I have a few losi 350 engines with that carb better pinch bolt as well with that carb

I broke down my dynamite .28rtr yesterday after putting countless gallons through it ND I gotta say there is no difference from the hpi f4.6 other than the looks of the crankcase everything is the same wat a surprise

Who makes the those back plate roto conversion backplates? I need those. Thanks

Wat do u use for solutions in ur ultra cleaner

Todd i know this is a older post but this carb is what i was talking about the other day with o rings. I got my engine used its missing the o ring on the idle screw and the top o ring on the carb that goes into the engine. Do you still have this set-up? If so would you be kind enough to get me a few measurements?

@NitroTalkwithTodd

7 ай бұрын

It has the stock carb, all metal with M logo?

@NitroTalkwithTodd

7 ай бұрын

Idle screw and are you referring to the o-ring that goes around the carb throat?

@joshherrman3201

7 ай бұрын

Yes the stock carburetor with the m logo. The fact idle on the back and the o ring on the main body that goes into the engine is missing the second top one.

@NitroTalkwithTodd

7 ай бұрын

@@joshherrman3201 the idle is 5mm(od)x 1.5mm, and I use 10mm(id) x1.5 for both the one inset into the carb throat and the one at the top of the throat.

@joshherrman3201

7 ай бұрын

Thank you so much I really appreciate it.