JBL Flip4 Firmware Update (how to)
Тәжірибелік нұсқаулар және стиль
This video explains the firmware update process for the JBL Flip4 wireless Bluetooth speaker.
The update of the firmware / software on the speaker requires an Android phone or an iPhone with the JBL Connect app installed. The app can be found in the Google Play Store or the App Store.
Once the app identifies the speaker, check for the little red dot on the settings icon at the bottom of the screen. This indicates that there is an update available.
The update process takes about 20minutes. Make sure not to close the app at any time during the update. Otherwise the speaker may not be functional afterwards!
Wait for the speaker to reset and restart on its own. Then the speaker and the phone can be used again.
Пікірлер: 98
That update was available over a year ago, i use it for a long time now, and it is great. Really recommend to update. iT's great.
@zacharyjosephs.tomelden8529
3 жыл бұрын
do you have to turn on also the bluetooth or just the wifi?
Holy shit .. I am doing it now ... ver 4 is out! Thx.
After the firmware update when I on my power on button it's doesn't sound like before the signature sound actually it's good or bad
always helpful🤙🏻
4.0 caused erratic battery reading. I charge it full. It takes like 2 hours (charger is 5v 1.5 amp). Then I listen to songs and in around an hour, the battery goes to one point (red) and it turns off. If I power up, it the battery shows 3 points again in an hour it goes to one point (red) and goes off. The cycle repeats and remember I'm not charging just restarting flip 4. I want to downgrade to 3.8 or 3.9. How can I do that?
Hey man my jbl is not turning on but flicking charging light. Whats wrong with it.
Playing while charging kills the battery? this one's doesn't work like a laptop when it's plugged in????
I’ve got (2) Flip 4s. I bought both one week apart. Last night, I updated one speaker from the app as prompted by the little dot on the bottom of the app screen. Now that the dot on the app screen is used and gone, how do I update the 2nd speaker?
@Mr1intension
2 жыл бұрын
Hi...did you find out about this? I have two as well
Those any one else have this problem were you connected your jbl flip 4 and you can’t hear your messages or notifications can someone help me ? Or what can I do
does this remove LFM?
I can’t get the app to find the device. Ugh
Thank you for mentioning 18 minutes time.
How about the friend sound changed in something I have version 3.2 worth updating to version 3.9
@AndrewsCookies
3 жыл бұрын
Yes
@frr9060
3 жыл бұрын
@@AndrewsCookies 3.9 to 4.0 its good to update?
Anything change?
Downloaded the app. It finds the flip 4. Says I need an update. I click on it but it says please turn off jbl connect+ to upgrade but no option to do that?
@danielgeorge3554
Жыл бұрын
you have to connect it to the charger and then back out of that page and get back into it to be able update it.
whitch version is good?
Ummmm- how do you connect it to your phone?!!!!????
How to connect it to JBL xtreme
What are the changes? :V
I tried it it doesn’t do nothing
No Update =(
can i do a downgrade to a jbl flip 4?
it doesn't work , I have tried several times to disconnect and reconnect the speaker to external power, but he doesn't want to know. I also tried to restart the app and the speaker, but nothing. If you can give me advice, tanks
@stefaniekurtz5815
3 жыл бұрын
i had the same issue. in the app you can see the list of compatible devices. there i chose the flip 4 and followed the instructions. i allowed acces to telephone and contacts, then the app suddenly found the flip 4. obviously JBL needs access to my contacts list, to update the hardware...
@leo_.07
3 жыл бұрын
@@stefaniekurtz5815 yes, I checked the compatibility, but unfortunately trying and trying again, it doesn't work the same .. even for too many attempts the app stopped me .. I don't know why ..
I have a JBL flip 4 where it does not play well when connected via bluetooth it kinda stutters (sounds like when you are beyond the allowed distance for a bluetooth connection) Any ide why this is so??
@krishnateja89
3 жыл бұрын
Late answer, but it might help others in the future: Resolution 1: If the speaker is connected to two devices, disconnect one. Resolution 2: If the device you are playing music from is connected to bluetooth audio devices, disconnect one. Resolution 3: Factory reset your JBL Flip 4 (there are other videos on YT with tutorials for that).
The App is now called JBL Portable
@colinlarkin2506
2 жыл бұрын
Cheers I'm looking for this app and dosen't seem to be same and there are a few choices. For people like me there is never enough information on these things.
My flip 4, only bought it for like half an year, is having a battery issue where it runs real quick. And when it charges, I find some problems like stopping the blink (which indicates it is being charged) stops at 4 point and never run to 5th unless I replug it. And the sounds are getting distorted when the light hit red which indicates the battery has run short. I get it if the battery is efficiently using the juice by not using its full sound quality but when I turn up the volume at that moment,the battery runs out and the speaker shuts down. I bought it as my travel accessory and it doesn't quite help me with my purpose.
@kaizen7852
4 жыл бұрын
@tommaso fochesato same here!!
@rockfella27
3 жыл бұрын
Same here. I am updating it to ver 4. Will keep you updated :)
@rockfella27
3 жыл бұрын
Done. It still doesn't charge past the 4th notch. Will charge overnight and see.
@rohanpo
3 жыл бұрын
@@rockfella27 How many time? i mean hour..
@AndrewsCookies
3 жыл бұрын
Bro, it is a battery issue. Unfortunately.
When I tap on the orange "update" bar, the bar turns grey and it has the words "I followed the instructions" written there. Which I did. And nothing happens. And the bar is grey and unclickable. I swear, the amount of time I spent trying to get this speaker to work properly... *clenches and unclenches fists slowly*
@juliuscaesaramora4390
3 жыл бұрын
just connect it to a charger
It keep on disconnecting while transferring What should i do 🤦♂️
@alistairstone2244
2 жыл бұрын
I have the same
HOW CAN I REMOVE THE UPDATE? I DON'T LIKE THE SOUND ..! :(
@apglong8673
3 жыл бұрын
Playpause button and + together for three seconds
@MegaSafetyFirst
3 жыл бұрын
Firmware updates cannot be removed that way.
@delosreyes__c
3 жыл бұрын
X2
@delosreyes__c
3 жыл бұрын
Amigo, has podido solucionar algo, tengo el mismo problema, se actualizó el firmware a 4.0.0 y el sonido ya no es igual.
Sir flip 3 Software pls
How we can check battery remaining percentage of jbl flip 4 . Make a video
@flingpigeon4198
3 жыл бұрын
It’s labeled on the app
After update Flip 4 can i pair it with Flip 5 ?
@MegaSafetyFirst
3 жыл бұрын
Unfortunately not. Flip4 and Flip5 are incompatible hardware wise.
@DonDomel
3 жыл бұрын
@@MegaSafetyFirst crap ;/ ;/ ;/
@colinlarkin2506
2 жыл бұрын
@@MegaSafetyFirst What about pairing 4 to 6?
I can do the update. Don't know why my speaker turn off in middle of this one
@juliuscaesaramora4390
3 жыл бұрын
same here! when I update JBL Flip suddenly turns off at around 10% of update
@juandavidcortesortiz383
3 жыл бұрын
@@juliuscaesaramora4390 just change the smartphone or the tablet to another
@juliuscaesaramora4390
3 жыл бұрын
@@juandavidcortesortiz383 Ipad, Note 8, even Iphone 12 won't do they all stop at 10% cause the JBL turns off
@bigriguk
3 жыл бұрын
Same problem unfortunately can't even find a fix
@liberian_tyo
3 жыл бұрын
@@juliuscaesaramora4390 you had the speaker plug in?
My buttery isn't work long time so what I do
@MegaSafetyFirst
3 жыл бұрын
In case the speaker is still under warranty, I’d contact JBL for a replacement.
That took about 28 minutes to perform the update from 3.2 to 4.0. Make sure you have some time set aside!
I got firmware update 4.0.0.0? what the heck
@alexcorreia3026
4 жыл бұрын
has anything changed?
@frr9060
3 жыл бұрын
same, share your review bro
@galacticacid2489
3 жыл бұрын
Yea, it's gonna update you to the newest version duh
i have fake jbl go 3 TG-117 how to download jbl fimware???? i need lfm mode
When start charging my jbl flip 4 the Bluetooth disconnects
@MegaSafetyFirst
3 жыл бұрын
Some Bluetooth speakers do not support charging and playing music at the same time. This may be the case for the Flip4.
@ramonbastos9490
3 жыл бұрын
@@MegaSafetyFirst but how can upgrade my JBL if I can’t charge it while it’s on ???
@ramonbastos9490
3 жыл бұрын
@@MegaSafetyFirst I’m trying to upgrade my JBL flip 4 ,I downloaded the JBL app and it says to upgrade it I have to keep the flip 4 charging but when I plug the charger the Bluetooth disconnects Thank you
@MegaSafetyFirst
3 жыл бұрын
Oh, now I remember. You are right, the Flip4 should definitely stay connected when it is plugged in. Are you able to start the update without plugging it in when the battery is above 50% charged? I believe there was a threshold for when they allow to update without charging.
@ramonbastos9490
3 жыл бұрын
@@MegaSafetyFirst no.. I left the JBL charging the entire night but when I plug the wire in the lights don’t even appear I’m trying to upgrade it because the battery is running fast
First
No entiendo nada soy español :'v
@alexfelix6699
3 жыл бұрын
Dice que hay una actualización de la bocina. Usar un celular android o apple, conectar tu cell con la bocina. Luego debes tener la aplicación en el mercado. Luego aplicar la actualización
@nicoo_.05_2
3 жыл бұрын
@@alexfelix6699 a ok gracias brother