How to Replace Front Door Lock Actuator 2000-2006 Chevrolet Tahoe
Автокөліктер мен көлік құралдары
Buy Now!
New Door Lock Actuator from 1AAuto.com 1aau.to/ic/1ADLA00176
This video shows you how to replace the lock actuator so that you don’t need to purchase an entire latch assembly in your 2000-2006 Chevrolet Tahoe. Power door lock systems typically use some sort of actuated motor to drive the lock mechanism. If the actuator breaks, then the door lock will no longer operate electronically.
This process should be similar on the following vehicles:
2000 Chevrolet Tahoe
2001 Chevrolet Tahoe
2002 Chevrolet Tahoe
2003 Chevrolet Tahoe
2004 Chevrolet Tahoe
2005 Chevrolet Tahoe
2006 Chevrolet Tahoe
Tools you will need:
• Flat Blade Screwdriver 1aau.to/obgm/1AXAA00013
• Pocket Screwdriver
• 7mm Socket 1aau.to/oa4Z/1AXAA00017
• Trim Tool Set 1aau.to/o7S/1AXXX00006
• T20 Socket
• T27 Torx Socket
• Ratchet 1aau.to/obvX/1AXAA00016
• Socket Extensions 1aau.to/obnN/1AXAA00015
• Pick 1aau.to/oMf/1AXAA00037
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Пікірлер: 9
√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money
Aye, thank you. You made my Sunday a lot easier for sure.
Thanks for keeping everything well lit so we can see what is being done.
Ty for extra time for step by step detail and camera still-shot check for corrosion. Later we can put dab of silicone grease on each connector and rod slide contact. Without this last greasing, EVERYONE will need another actuator within 5 years. The binding and friction is what made the failure in the first place. The lesser used locks will be next to go.
I replaced mine and sometimes the lock binds up, and feels like the bars are not allowing full movement. (Its not the lock cylinder)
Would the new door actuator make the door feel a little rougher to close upon contact with the door jamb hooking assembly thing? Mine feels a little rough upon closing with a new actuator🤔
How do you get the door open mine won't unlock to open