How To Get Full Penetration On Thick Steel / Complete Penetration Tutorial

Ғылым және технология

The welding was done with 7018 electrodes on 100 amps with an Amico Power welding machine. The steel was 5/8" thick with about a 30 degree bevel in each piece. The hardest part of this process is the grinding of the back of the weld. It's just the most time-consuming part of this process.
I'm more than willing to answer any question you may have about welding or metallurgy, so ask away in the comments.

Пікірлер: 6

  • @MannanFancybirds
    @MannanFancybirds2 ай бұрын

    Hi, i have a question if we perform the butt welding on steel plates 10cm wide and 5 mm thick. Can we use this sheet to produce the coil by hot rolling? Will the joint sustain the hot rolling process?

  • @musthakahamed28
    @musthakahamed284 ай бұрын

    What is the welding symbol?

  • @michaelpayne8668
    @michaelpayne86686 ай бұрын

    Would u say it’s normal practice (if needed), to full penetration butt weld 2 load bearing I-beams together on residential house?

  • @kickemassicus

    @kickemassicus

    Ай бұрын

    I would say yes

  • @mikeknowshow
    @mikeknowshow Жыл бұрын

    What did you use to bevel the pieces? Angle grinder?

  • @FerrousPhoenix

    @FerrousPhoenix

    Жыл бұрын

    Just an angle grinder with a grinding wheel.

Келесі