Well done...I like this approach because I don't want to bother with the parking mode. Thank you

Fantastic video. Great job

Very nice and well explained 👏 💪👍

Hey, what’s that other thing mounted on your windshield?

Non garmin video related, but what is the carabiner under your dash for?

What’s the name of the kill switch plug you got

For parking mode does it matter what fuse is used. As long as it's always on that's all that should matter right?

whoa!

you didn't want want the constant power to the dash cam?

New Subscriber & I rang the notification bell. How many amps did you choose for each of the fuses?

@TrevsGarage

2 ай бұрын

Thanks for the sub! I used the original fuse for the one then a believe a 2a for the dashcam

@azclaimjumper

2 ай бұрын

@@TrevsGarage I've just successfully hard-wired my Garmin 57 into the electrical system of my 2009 Toyota Yaris. I wired a red & yellow wire into the electrical system, as I want the Park Mode feature of my dashcam to videotape everything while I'm parked & the engine is turned OFF. I cut off the butt crimp connector at the end of both Fuse Tap Adapter & replaced it with Bullet quick connect/disconnect, I made certain to crimp the FEMALE Bullet Connector to the end of the Fuse Tap Adapter wire. If, for any reason, I decide to disconnect the hard-wiring kit, there won't be bare metal that could cause problems. The MALE Bullet connector I crimped onto the dashcam wires. I, personally, prefer Bullet quick connect/disconnect rather than spade. Also, the Bullet connectors I used are insulated & have heat shrink which makes for a clean, waterproof connection between wire & connector after being crimped. Warm Regards from Reno, Nevada

Chrevur - wad u dooo when itz -45° C rimoov the dsshkam؟!

You should also tell everyone that the upper addition of the 5 amp fuse always has to be smaller then the main fuse your pulling out and in which slot it goes.

@dolaward

2 жыл бұрын

Does every fuse have to be smaller down the line? I have an accessory that has a 2 amp fuse on the adapter

@TrevsGarage

2 жыл бұрын

What you are adding to the fuse tap cannot be larger than the original fuse or it will most likely pop it

What brand fuse taps?good job on the video 👍

@TrevsGarage

3 жыл бұрын

If i remember correctly the fuse taps came with the kit.

With that kit it’s a 12v to 5v converter did you use the converter or just the fuse tap and your own wire?

@TrevsGarage

2 жыл бұрын

You need the converter so i kept it attached and then fuse tap

@shoop52

2 жыл бұрын

@@TrevsGarage thanks and thanks for the video

@tufcat722

2 жыл бұрын

@@TrevsGarage Thanks for this, this is great. When I looked at the Garmin Mini 2 specs, it says input voltage 12-16V, output 5V. Given this, it sounds like you wouldn't want to step down. I'm a noob, wondering if would know why

@philipiano001

7 ай бұрын

Mini 2 cable runs off a 5V USB A plug. I used a CPT 12V to 5V USB A converter plugged into the fuse box via a piggyback fuse tap. I attached the converter to the IP with Velcro tape. 🤓 All wires hidden.

Do you ever have issues with the camera randomly powering down or rebooting with this kit? I just did this same install with the same kit yesterday (2019 Ram using sunroof fuse) and the camera randomly reboots while driving. All firmware is current also.

@TrevsGarage

Жыл бұрын

I have not had any issues with a similar install in multiple vehicles. Do you know what the fuse you tapped powers?

@moellerimaging

Жыл бұрын

@TrevsGarage I use the 10A fuse for my power sunroof. My truck doesn't have a sunroof but there's a fuse in that slot and it's an ignition only slot 🤷🏻‍♂️

@TrevsGarage

Жыл бұрын

Thats interesting have you tried any others? Could possibly be an issue with the camera perhaps is it a mini 1 or 2 camera if you know?

@FunAndEZ

Жыл бұрын

Were you able to resolve this? I’m having the same issue with this kit and the Garmin mini.

Nice video but I have a question. If you use an ignition on fuse then how will the cam operate in parking mode? This has parking mode so it needs power even when the ignition is off. Can you please clarify this?

@TrevsGarage

2 жыл бұрын

You need the “parking mode accessory cable” for the Garmin mini to work with parking mode and I’m not using that

@algebruh_m8652

2 жыл бұрын

@@TrevsGarage Yeah I wont lie I thought that's what this video was about. At this point this kit is useless unless you don't have a spare cigarette lighter. And some cigarette lighters actually stay on all the time. I was looking for the camera to stay on all the time

Finally

A video with watching

Very gud videYo greyt efurt and niysly expleiynd. Gud wurk in geting it dun by yurself. A exsepshin woud bee showing the wire routing. To mee who am nat familyir with theeze dash cameraz nor with jiyint trukz/reely modern karz, i koud nat see where your power kabilz are and also there lookd to bee 2* cameras mounted, slower more deliberit film foodij on showing thowze woud hav been more helpful. Thankz a lat!