best one yet , others are no way as clear as you

Excellent tutorial. Thank you. My slide cables are nowhere near that bad. After watching I'm looking forward to getting them perfect.

This is the best tutorial I’ve watched on this type of system. I’ve got some slides acting up. I replaced the gear box on one, worked perfectly! Need to do same on another. But now my third is sticking. So, I’ll be adjusting it today and this video has helped! Thank you

The white anti vibration foam blocks are missing at every block. That's probably why the system gets slack in it. If these are missing, the factory installer left them out or someone removed them

@blake.alexander

9 ай бұрын

Won’t be long before it happens again.

You are very good Mechanic, You must be in high demand, most of the time folks would have to go to a dealer. Stay safe! :-D

Nice Job, Thank you

What about checking for cables rubbing on the brackets going in and out? One side of my cables are rubbing I think I need to loosen that side a bit

Great video. Mines way off on the bottom and top a little bit. Getting some leaking on the top of the slide. Hoping it’s the issue

Great video. I notice that after using slide seal conditioner on the seals my larger slide jerks/jumps at bottom when it first comes in or almost is fully extended out. My cables are all tight and blocks are straight but unsure after the seal maintenance why it's doing this at the bottom now.

I think the cable is worn because the cable is rubbing on the aluminum bracket when it goes in and out.

Great tutorial! My cable came disconnected last weekend and I had to get the slide out and in as we were at a concert. I got it re-connected but I believe I have the chain in a different spot than the other one. At the beginning of the video, you mention measuring to be sure they are even. So is what I need to do - Measure the chain on the side that didn't come off and then make the other side the same length by moving the chain on the sprocket, then adjust the cables?

Good video. My slide motors annd cables are on the bottom and very hard to get to.pain in the butt.

You need to tighten the jam nuts

Great video, and just in time. My cables are loose like the cables in your video. Do the slides need to be fully retracted to adjust them? Thanks

@thenomaddetailerrepair2375

Жыл бұрын

About half way or enough that you can reach the cable blocks above.

@RamblinRoadies

Жыл бұрын

@@thenomaddetailerrepair2375 thanks

Question My cables are loose, My box has shifted 1 inch left Do i need to more than just adjust as your showing in this video ?

@MVaccaTTACK

3 ай бұрын

It shouldn’t shift side to side. But get them all adjusted properly first and then check again. I just got an RV with this system and my bottom is way farther in that the top. They are not flush at all

Loud pop noise when closeing

Bal Accu cable slides are junk. if its not the cable breaking its the motor going out or the gearbox striping.I have replaced all of them.

The mfg. video is better.