valuable! we need more ranger repair videos

Great video, would love a little detail on removing g Cooper washers and before and after look at cleaning the ports. Again, love the work

THank you for wonderful on the HOW TO REMOVE FORD RANGER T6 injectors procedures. VERY USEFUL.

@btdgarage

2 жыл бұрын

Thank you

MAAAN awesome! Such an awesome vid! thanks a bunch man! Indeed would love to see more T6 repairs (got a T6 2014)

@btdgarage

2 жыл бұрын

Thanks bro

Nice vid. I had an injector base washer start leaking compression into the cam housing. It had the same symptoms as a broken piston ring or piston ie puffing grey smoke from the catch can or oil fill hole. Except there was no loss of power but engine oil got dirty and blew grey smoke from exhaust on engine start. Inspect the base of the injectors for flame traces just above the washer.

Great video... thanx🌹

Is it possible to fit a borescope down the injector bores and into the cylinder or is the bore too small? Thanks.

Very useful man keep it up 👍🏾

@btdgarage

3 жыл бұрын

Thanks bro

hi good video, have you got a video of how you cleaned the injectors. thanks.

WARNING. Do not follow this tip of taking the 4th cylinder plug cap off the injector. I did this to save time rather then taking the wipers and bonnet seal off. (Note I was reusing my injectors, took them out to replace rocker cover gasket) when I reinstalled it all, cylinder 4 injector no longer worked. Must have disturbed the magnets inside the injector. $200 later for a second hand injector, problem fixed.

Bro.. Why there diesel around the rubber cap at nozel when engine were start..

Continue

@vikingpestcontrolaustralia1826

Жыл бұрын

Hi mate. Do you need to reprogram the ecu with the injector number or just swap out?

ford ranger t6 2016 whats rong when its going limp mode

@btdgarage

3 жыл бұрын

Best to have your vehicle scanned first.