Okay understood thanks very much for getting back. All the best. R

i have been following your website and youtube since 2019 , Keep up loading video and track day video. I have an evo 4 also

@wrenchrampage

5 ай бұрын

Thanks for yoir support

Nice review. Short and to the point. Thanks

@wrenchrampage

5 ай бұрын

Thanks for watching!

Sorry meant to say 3:20. Cheers.

I have been thinking about getting these, as car does shake a bit when starts.

@wrenchrampage

5 ай бұрын

Yeah they are definitely a good mount

most important, its lighter than stock.

Hi. I’m doing same mod and the hole in the front bush on the north south bar is way bigger than the rear. But the bolts are the same and the front bolts slops around in the bush. Is there a sleeve that goes in the front mount? Your vid at 3:30 shows the different size holes. Thanks in advance if you can help. Rich.

@wrenchrampage

2 ай бұрын

Yes, the stock set up has the same sort of design. The hole is larger than the fastener. This is correct.

im seeing they have set for evo 4 part number 560 911 and evo 5/6 561 911, i have an evo 4 with evo 8 engine, evo 6 trans and t-case , what should i get ?

@wrenchrampage

5 ай бұрын

I would send cusco an email and ask. I think you may need to use the 4 specific ones but i am not 100%.

Does it mean it will send more noise or vibration to cabin after installation compare to original mount and rubber?cheer

@wrenchrampage

2 ай бұрын

Yes it will for sure.

@kwunchiuyau9208

2 ай бұрын

@@wrenchrampage do you recommend oem product over Cusco’s in terms of comfort? Assuming only minor mod for my Evo

@wrenchrampage

2 ай бұрын

​@@kwunchiuyau9208yes, if you have only minor mods stay oem

How bad was the NVH after install?

@wrenchrampage

5 ай бұрын

My petsonal opinion is its tolerable, but i also have experienced solidmounts. I dont think the vibrations will bother me.