For even better quality, take the corners and hole down with a 1/4" round over bit. It will look really good, and will save the bags from ripping.
@thepioneerworkshop1218
3 жыл бұрын
Thanks I will on the next set I build.
@stevewetrich2818
3 жыл бұрын
Also, I do like the looks of the satin as well
@stevewetrich2818
3 жыл бұрын
And I like to inset the frame an inch all of the way around
@thepioneerworkshop1218
3 жыл бұрын
@@stevewetrich2818 So are you using a dado and dropping plywood down 3/4"?
@stevewetrich2818
3 жыл бұрын
@@thepioneerworkshop1218 no... with the one inch off set and 1x3 frames it keeps the tops within ACL league standards
@lerrico3 жыл бұрын
What stain color did you use for the hole section? Looks like natural in the middle, maybe hickory on the edges sides and bottom! They look great!
@thepioneerworkshop1218
3 жыл бұрын
Hi, I used Dark Walnut and natural stains. The hole section is painted black same as the stripes. Thanks Denny
@maxd9632 Жыл бұрын
very nice
@Dan-wo9bb Жыл бұрын
Hi. Nice job on them. Boards // what. U. Used. First. Hardware for. Bags. ???
@JAW_732 жыл бұрын
Do both boards play the same? Is the gloss faster than the satin?
@drewanderson1999
2 жыл бұрын
I’m not sure what brand of poly he is using but I made a few sets with behr satin(x4 coats) and they are way slicker than gloss. Satin does look better but they are really hard to play on.
Пікірлер: 13
For even better quality, take the corners and hole down with a 1/4" round over bit. It will look really good, and will save the bags from ripping.
@thepioneerworkshop1218
3 жыл бұрын
Thanks I will on the next set I build.
@stevewetrich2818
3 жыл бұрын
Also, I do like the looks of the satin as well
@stevewetrich2818
3 жыл бұрын
And I like to inset the frame an inch all of the way around
@thepioneerworkshop1218
3 жыл бұрын
@@stevewetrich2818 So are you using a dado and dropping plywood down 3/4"?
@stevewetrich2818
3 жыл бұрын
@@thepioneerworkshop1218 no... with the one inch off set and 1x3 frames it keeps the tops within ACL league standards
What stain color did you use for the hole section? Looks like natural in the middle, maybe hickory on the edges sides and bottom! They look great!
@thepioneerworkshop1218
3 жыл бұрын
Hi, I used Dark Walnut and natural stains. The hole section is painted black same as the stripes. Thanks Denny
very nice
Hi. Nice job on them. Boards // what. U. Used. First. Hardware for. Bags. ???
Do both boards play the same? Is the gloss faster than the satin?
@drewanderson1999
2 жыл бұрын
I’m not sure what brand of poly he is using but I made a few sets with behr satin(x4 coats) and they are way slicker than gloss. Satin does look better but they are really hard to play on.