Brilliant

Thanks. Good to know. I'm about to try adjusting the cable, as mine doesn't engage Forward immediately -- slips, then clacks, then pops in. Now to figure out why it's not shifting out of 4WD...?

@JoseTrejo1

5 ай бұрын

It could very well be the switch. As a heads up, While I was servicing the Coleman 400utv I found various connections not fully connected where the retention clip was not even engaged over the locking tab on the receiving connector. I was blown away at the lack of execution taken on this machine. Go over your connections and make sure everything is properly seated and secure. You can likely check continuity of the 4wd switch if you have a meter.

@JeffKnoxAZ

5 ай бұрын

Thanks a lot for the response. I think it probably is the switch, either a bad contact or other bad connection. Tomorrow. Thanks again.

Mine has a shift problem that just started. It's 6 years old and just started. Reverse works fine. In drive it goes, but will buck and grind a little, like something is slipping a little. Any thoughts that this could be related to your shift issues?

@JoseTrejo1

Ай бұрын

Yes. The gears are pretty solid for the unit design. Typically it’s just not engaging all the way like it should. You likely rounded the gear out where it was making contact. How many miles or hours on the unit? Doing the rebuild isn’t that difficult if you have a little know how and willingness to dive into it, it’s just a little time consuming. Please send me a email (see video description) and we can discuss it further if you would like.

Yes please how can I get this I have a Colman ut400 with the same issue

@JoseTrejo1

4 ай бұрын

Contact info located in video description

I need to get one of these brackets! Could you pass me the info that I would need to get one?

@JoseTrejo1

7 ай бұрын

Please email me directly at jose_t5150@hotmail.com I will have the machine shop get a few made up this week and ship when I get back from vacation