BMW N47 Balance Shafts Removal and Installation Procedure
Автокөліктер мен көлік құралдары
How to remove and re-install the Balance shafts / Compensating shafts on BMW N47 diesel engine. In the video we going to replace the balance shafts needle bearings and we going to show how to properly install all the spline gears + the idle gear to the crankshaft, so to avoid any unnecessary vibrations or noises.
First part of the video:
• BMW N47 Timing Chains ...
BMW N47 Balance shafts removal tool:
www.ebay.co.uk/itm/404456879889
BMW N47/N57 front crankshaft installation tool:
www.ebay.co.uk/itm/404456468499
BMW N47 engine stand tool:
www.ebay.co.uk/itm/404282002089
Support the channel : / crankauto
Shop coordinates ( for business inquiries ) : / crankauto
CRANK
Пікірлер: 15
Really great detailed video, thank you for making. Sadly my N47’s balance shaft bearings have completely failed, new engine ordered :-/. I didn’t know these were an issue otherwise I would have replaced them when I had the engine out for a new chain and seals 30k ago 😭.
Amazing content. Will subscribe!
All n47 16d doesn't have the balance shaft from factory and runs nice
And one more question i get error low fuel pressure in rail, when i fllor my car at around 4000rpm, i have changed rail,HPFP, valves at them and sensor on rail, and fuel pup in tank, but sill i get same error and car enters limp mode?
Very good videos!! I have a bearing defect on my N47D20d from 2012 with 218hp. When I took it apart I noticed that there were no balance shafts installed! Did anyone remove them beforehand or are there engines without balance shafts? Many thanks for an answer. Regards Rolf
@yokash7570
Ай бұрын
try looking in the holes if they are damaged they removed em but they can drive without em its mostly made for comfort
@CRANK what's your opinion on deleting balance shafts?
@crank3646
3 ай бұрын
It will be cool experiment but the influence on the timing chains and the bearings will be seen on a long run
@lixtronicgarage9156
3 ай бұрын
@@crank3646 agree with chain part, after all balancer are for smoother running so less vibrations, but imo bearings only suffer from tensinon and torque that it gets from pistons, not so much from given vibrations that could occure with BS delete
Ace ✌️✌️✌️
Do you think it is good idea to remove them, my car does not have them, and it works find no hard vibraitons, nicer sound, btw i bought it this way?
@crank3646
3 ай бұрын
I don't know, I have never tried to assemble it without them. I know Alfa Romeo engines can run without them
👍😎
ты русский что ли?