Nice video. Everything you need and nothing you don't Well, the cow was unneeded, but entertaining.

@jackstandnation

Жыл бұрын

Thank you!

Just got this kit installed on my 02 and it has been great

@david-zm4yn

Жыл бұрын

Ññ lo Ññ

@angelmorfin3597

4 ай бұрын

How big are the tires your using bro?

@Amarillobymorning777

Ай бұрын

How much for the 2 “ lift kit??

Awesome content!! Thank you 👍👊👏

I've been watching a ton of WJ vids lately. Seen most of them 5 times over. I've had '99 for 18 years and I'm starting to build it this year. It's nice to see a fresh new WJ video. Good job.

@jackstandnation

Жыл бұрын

Thank you soo much! 😊

@albertfs4754

6 ай бұрын

how's it going with your project? what kit did you go for the lift?

@johngaston308

6 ай бұрын

@albertfs4754 haven't made it that far yet. I'll probably just do Fat Bob's 2.5". I had to rebuild the engine and trans coincidentally/luckily 1000 miles apart.

Looks nice.. nice video

Why not put a new rubber springisolaror on the rear springs? Now it's metal on metal!

Great video, thanks for posting! I just purchased the same Rough Country 2" Lift Kit for my '04 Grand Cherokee. Can you please confirm that the rubber rear lower coil spring insulator is not required when installing this Rough Country Lift Kit?

does the castor angle need any adjustment , how does it drive, i see these getting death wobble when lifted 4 inch but this 2 inch lift looks pretty good .

What size tires and rims wheels are those? Also what size wheel spacer? Building a 04 WJ right now

Use the factory shock cross pins on the front shocks. My wj didn't make it out of the drive before breaking. 265/75/16 load range E tires rubbed in reverse on incline, but not going forward.

@minamusiklistor9319

2 ай бұрын

245 wide is the biggest you can go without spacers, I belive.

Nice, do you have a link to this kit?

please tell me the size of the width, they look great

I was thinking about paring these wi to the roughy country 4in long arm to make around 6 in in lift because 3000$ is to much for Clayton’s 6 in lift , if I do this is there anything I should know

Estoy haciendo los mismo en mi wj que amortiguadores colocaron ? Muchas gracias

did you have problems with stock springs falling out or bowing out after the kit installation?

I remember doing my xjs. Wow those very rear bolts on the leaf springs were such a bitch to get off. Used a breaker bar the entire time backing them off. Couldn’t get an impact on em. Smh

What size tire without rubbing

Hey brother, do you know if 33 inch tires will fit with a 2 inch lift kit?

What is a tire size?

What size wheel spacer are u running on wj

What size wheel spacers are you using

Those on factory wheels still?

What size spacers you got? I wanna go with like a flushed look but kind of poking out wheels

@jackstandnation

Жыл бұрын

Im not quite sure because it wasn't our jeep but they were pretty small. Maybe an inch or so

What tire size do you have

"Hi, I wanted to ask if raising the height of your vehicle by 2 inches has affected its handling on the freeway, especially when taking turns. I think the difference might not be significant, but the last time I raised the height of my vehicle decades ago, it also had larger tires which made the ride louder, like on a dirt bike. So, I'm looking for a compromise between the height and the noise. Also, did you notice any changes in mileage after raising the height? Your instructions make it look plausible for someone like me to do it myself. Thank you, and take care!"

@jackstandnation

4 ай бұрын

It still drives pretty well with the lift due to it being such a small lift. Mileage is about the same to my knowledge. We installed the lift for a family member so I haven't really driven it since.

@cloubert01

3 ай бұрын

Did it increase ground clearance? Was this a quadratec?

How do you like this kit after being in use for awhile? Handling and ride quality still there? Getting any noise issues that I have read about? Considering this kit myself; Thanks for any info you can provide...

@semiprofessional8470

Жыл бұрын

I've been running it for a few years. Stock tires. I'd get an alignment just because. No problems so far

@NinoMaartenGuitar

10 ай бұрын

been running it for 2.5 years now with 245/75/16 setup. So far so good. Front driveshaft doesn't like the lift so I removed it as I mostly drive on normal roads.

@SenzuBeaner

8 ай бұрын

@@NinoMaartenGuitaryou can still drive without a front driveshaft?

@NinoMaartenGuitar

8 ай бұрын

@@SenzuBeaner yes. The WJ is rear wheel drive and only uses the front when needed. So far I've been driving around without the front driveshaft for 1.5 years and zero issues.

@worldoftanks787

7 ай бұрын

⁠@@NinoMaartenGuitarI had same issue with my front shaft, found a double cardan at a junk yard for $50 and it’s been great since.

what size spacers? and was there any rubbing before you lifted it ?

@jackstandnation

4 ай бұрын

I don't remember the size of the spacers. It was for a family member so I didn't drive it much beforehand to know of any rubbing.

What size tires are on it before it was lifted

@jackstandnation

8 ай бұрын

Tires are same size in the video.

On rough country site it says the kit won't fit my 2004 wj 4x4 . Do you know why?

@angelmorfin3597

4 ай бұрын

Bro me too smh the website says it doesn’t have the kit for my jeep either

Does this increase ground clearance? And can it be used in a quadratec?

@CozyBear_29

18 күн бұрын

Rough Country website says No on the Quadra -Trac

tell me what brand of wheels are installed on your jeep

@jackstandnation

8 ай бұрын

06 Jeep rubicon wheels

31”?

What size are the rims and tires ? Thank you.

@jackstandnation

Жыл бұрын

They are 17" Rubicon wheels from a 2004 Wrangler. They have been repainted recently

@ikedinobi6345

9 ай бұрын

​@jackstandnation HI, the wheels are 17 but what size are the tires? Are those 245/75/17? or 265/70/17? Thanks

Worst thing you can do is lift springs and lift pucks, in order to do a correct lift is to do extended links and arms and just lift coils then use those shovk absorbers

@jackstandnation

8 ай бұрын

It was for a family member and he ordered the kit. Actually rides really nice.

@benbirch2393

8 ай бұрын

My 03 WJ with Old Man EMU springs and dampers (not long arm), rides beautifully on and off road, and I've never been hung up or had issues going where I need to go. Okay I won't be doing crazy rock crawling but that suits me

Did you not bolt the spacer in the front it comes with a bolt to bolt it in

@jackstandnation

Жыл бұрын

Nope...I guess we forgot lol

@getitdone361

Жыл бұрын

@@jackstandnation now ya did it lol yeah recently did on mine it come with the 19mm self taper bolt to bolt up the front spacer is it not knocking or making noise not being secured down?

@jackstandnation

Жыл бұрын

We didn't get a complaint or anything yet but if it starts making noise we will put the bolt in. Seems to be A-Ok so far lol

@getitdone361

Жыл бұрын

@@jackstandnation lol shit happens

@paulbuchanan9914

Жыл бұрын

@@getitdone361 Unless you disconnect the sway bar there isn't a need to secure the spacer while running short arms.

Do you need longer brake lines?

@jackstandnation

Жыл бұрын

Nope...you just bolt the kit in. Its pretty easy and it still drives well!

shoulda replaced them rusty springs hahah great video tho

@jackstandnation

4 ай бұрын

haha it was for a family member so they just gave us the lift and we installed it

@curryreeves1369

4 ай бұрын

@@jackstandnation yeah just being a troll lol but seriously inspired me to do mine since it’s kinda straight to the point

@jackstandnation

4 ай бұрын

@@curryreeves1369 Oh awesome man! Im glad this video helped someone lol

These kits are a waste of time and money....first of all if you put this kit on a older jeep your not getting a 2 inch lift cause the stock springs are shot so you need new ones. Save up some cash and buy a 4 inch lift kit that way it's a whole new suspension at the height that looks badass 🤘

@Raid-qx4jv

7 күн бұрын

I put 2.5 spacers on my 04 and honestly if ur not hitting trails to hard and just want some height then spacers are a good alternative