This is my kind of teaching/learning! It kind of makes me think that I can do it!😊

@Good-Enuff-Garage

3 ай бұрын

Ditto

Really helpful! I'm working on getting zombie contactor control going using test setup and ISA shunt

Rants are good,

@Good-Enuff-Garage

3 ай бұрын

😳

Brilliant explanation.

@Good-Enuff-Garage

3 ай бұрын

😊

You're a saint Greg.

@Good-Enuff-Garage

3 ай бұрын

Go on...

@TheSilverBuick

3 ай бұрын

@@Good-Enuff-Garage Handsome too!

Another great video Greg. explaining things in a straightforward manner for the masses. As a matter of interest - did you buy your Zombiverter fully built, or did you buy the one that required some soldering? and if you did, was it just the connector, or was it some of the electronic components as well? Cheers

@Good-Enuff-Garage

3 ай бұрын

thank you, I did not buy mine fully built, I bought the header off of Ali Express I hope to make a video on soldering the header on and building the wire harness

Pre charge voltage or udcsw should be just (like 20V) under you minimum expected battery voltage ever.

@Ghia66

3 ай бұрын

What is the reasoning for this? 😊

@Tom-evnut

3 ай бұрын

@@Ghia66 You want to limit the rush current when closing the main contactor. So you want as low a voltage difference as possible to the actual battery voltage

@Ghia66

3 ай бұрын

@@Tom-evnutThanks Tom😊

@Good-Enuff-Garage

3 ай бұрын

thank you