great instructions. judging by the honey its been awhile for clean fluid

The Haynes manual suggests leaving the master cylinder connected and pumping out the pistons (two at a time) with it. Makes sense if you don't have access to compressed air.

@MotoGarageTV

27 күн бұрын

That's a good way as well. It does get a little complicated once you have one side out. Piston pliers work well if you do not have a compressor. I plan on uploading a video in the next few days to go over that way as well. Thanks for the tip.

Great instructions

@MotoGarageTV

Ай бұрын

Glad it was helpful!

I think you did a great job. Thank you VERY much!

@MotoGarageTV

8 ай бұрын

Thank you too!

Thank you so much for this video. I've just doing this and it helped a lot! Amazing videos, hope there will be more :) Btw do you know maybe does seals from some other models fits also? Thank you!

@MotoGarageTV

4 ай бұрын

Thanks. I'm not sure if other seals would work or not.

See those two silver star-shaped things on the calipers? What are they, and can they be replaced?

@iceman1213kay

6 ай бұрын

You can remove them with a blue dot caliper tool. Cost about £15. No need to replace them but if you remove them there is a seal that will need replacing before installation.

@MotoGarageTV

5 ай бұрын

Thank you for getting back to this answer. You are absolutely correct. There is no real need to replace other than to change the color. These came in a few color variations. Good luck

You've no clue how to strip a caliper.

@MotoGarageTV

9 ай бұрын

I'm happy to learn a better way. Send me the link to your video. Thanks

Is there an orientation for the seals ? I heard something about a lip ? How do you know which way to install ?

@MotoGarageTV

3 ай бұрын

There is, it's noticeable hard to mix up once you see the new seals. There are 2 sizes as well, which both have an orientation to them. Hope this helps.

@dickquist9483

3 ай бұрын

Hi received the kit today but i cant seem to find the right orientation. Feels like a small lip but looks the same. How did you find the right orientation on the new seals ?