Looking forward to some videos where you take it out for a spin. Would also like to see any ideas you might have of ways to USE the Go2 for tasks, even if it's more of a nod to future uses. I have a strong interest in seeing how these might be actually useful to own for the average person in the future.

@teslabe7701

3 ай бұрын

I will be doing a video showing the "follow along" feature as soon as the weather gets better and will show it's voice control and it's limited programming capabilities . As for the robot doing "tasks", this is the pro unit, the "education" unit is the one that can be programmed to do autonomous tasks like patrolling, inspection of your warehouse and more, but it's $10,000, I was just looking for a cool toy and found it here with this bad boy....

@joelface

3 ай бұрын

@@teslabe7701 very cool! I look forward to more videos with your very cool toy!

did you read him his rights?

@retro93277

3 ай бұрын

lol good one

@teslabe7701

3 ай бұрын

🤣🤣🤣 To be honest, it's had not to see her as a living thing and feel bad doing this, but it's very hard to move the robot if you don't tie off the legs

Have you ever had to use Unitree for support? My Go 2 Pro arrived with no battery. Endless emails to different accounts and nothing!

@teslabe7701

Ай бұрын

Sorry for the late reply. Yes, I do have experience dealing with Unitree support and so far it's been good. My robot came in two boxes, a large outer box, then the box with the robot inside. My battery was packed in the outer box along with the large remote I ordered extra and the leg calibrator. How did yours ship and who did you order it from? Unfortunately, it's going to be your word against theirs as to if they indeed shipped the battery, good luck....

I want one with (fake) fur!!

@teslabe7701

Ай бұрын

I'd be very careful putting anything on your robot that could cause the motors or electronics to overheat, or get tangled up in the robot's joints. I'm sure it would look cool but just be very careful how and where you attach the fur....😵‍💫

I came up with a simple way to transport a dog. Open the largest portal with 3D printing and search...

@teslabe7701

3 ай бұрын

There are so many reasons why I would not do that with my robot..... The weight of the legs and the concentration of force at that point could easily damage the bearings of the two hip pivot motors. Also, not knowing what's behind those plastic covers, they could collapse and damage something like the encoders used for position feedback and lastly, I'd be concerned of the 3D part getting crushed, but it is your robot, so......🙄