So how did you bolt the winch plate to the bed?

how bad does the deck get hung up on the edge of the tailgate where the ramps hang off? do you just power through it or have to give the back of the tractor a lift to clear?

@NissanPRO4X

6 жыл бұрын

machinesnmetal it's tractor dependent, there is only about 1/4" space with the Husqvarna so it's close. I have wood spacers that I can use to change the ramp angles by lifting that ramp off the ground.

@machinesnmetal

6 жыл бұрын

I find the john deeres seem to get hung up less than everything else. The zero turns are the most hassle because they are usually longer and the castor wheels tend to fight the ramps... I mounted my winch up a bit higher, at the top of the box cap

Where did you plug in the cables for power? Does it reach the battery somehow?

@NissanPRO4X

5 жыл бұрын

Used a portable battery box.

How did you get that bolted on there? How did you push the bolts through? From underneath somehow?

@NissanPRO4X

5 жыл бұрын

The washer I cut a flat on two sides to allow it to slide over the bolt then slide the washer into the track and rotate the washer until its seated. I know longer have the truck but it works like the Nissan track lock.

Where did you get the channels that you're using to hold the winch plate?

@NissanPRO4X

5 жыл бұрын

Those are factory from Nissan. Every frontier comes with them installed.

What size bolts and washers did you use

@NissanPRO4X

4 жыл бұрын

I no longer have the truck or the hardware. I used what I had available at the time and made it work.

nice man , for what is it ?

@NissanPRO4X

8 жыл бұрын

it's used with ramps to pull machinery up into the bed of the truck. it can also be used to safely unload items down a ramp.

@HeliMouse

8 жыл бұрын

+Inverted Hover Great for your back no heavy liftings good stuff