Hey flip your rear bearing blocks put the left on the right. And it takes almost all of the rear toe out of the Dr10

Your reason for toe out is the reason for toe in from what I’ve understood. Maybe that’s just for 4wd sedan, pancars n bashers? 4wd will pull under load causing more toe in up front and toe out in the rear because of the caster angle is more up front. Rear wd the front tends to want to toe out because the caster angle. If you take off the tie rod the front wheel will toe out naturally unless being pushed forward. Toe in makes the front want to track straight and initiates the turn slower (lazy), then in the rear to pull to the center. Toe out wants to initiate the turn quicker for the front, not enough toe in for the rear and the rear is squirrelly because it naturally wants to toe out under load. Haven’t ran my no prep yet but I’m thinking 1 1/2 toe up front with 1 degree camber to keep any input lazy and wanting to track straight for the front and 1 degree camber with stock rear toe to start,looks like stock is 3 degree but I might play with 2 degrees to help the rolling resistance. Is there a follow up vid on your results.

Good content man . Dropping the knowledge out here haha the chassis set up is just as important as the esc motor combo , and I'm glad you are showing this kinda info

@Dorkyand40

3 жыл бұрын

Very true! i over looked it and it cost me..also the wreck damage i had to waste time putting back together..appreciate the kind words and for you stopping by

AWSOME, thanks for that, validates my thinking as I set up my hybrid dragslash/Losi/lc racing… (don’t ask) rc drag car. Umm could you define wonky, I think it means the same as bejigidy right ? 🤣

Great info. The toe setup plates are a cool little kit. How do you square the rear end of the car in relation to the table/square when using them?

As usual good info Bro.

@Dorkyand40

3 жыл бұрын

Thank you my man

I have reached out to Barth concepts. No reply. What is the link to buy the toe gauge kit. Thank you

@Dorkyand40

Жыл бұрын

think he got you now!!

Where can I get that setup station will it work for my slash ??

@Dorkyand40

2 жыл бұрын

Rcplanet had them.

Does anybody make a sway bar assembly for the DR10 front?

@Dorkyand40

3 жыл бұрын

Not that I’ve seen.

@Pavestar1

3 жыл бұрын

Externally limit the front shocks acts like a anti roll bar

@markdickinson2769

3 жыл бұрын

@@Pavestar1 good 💡 idea! Thanks.

What part of Ohio are you racing in?

@Dorkyand40

3 жыл бұрын

Mansfield brother

Where can I get that toe gauge?

@Dorkyand40

2 жыл бұрын

You want the set from Barth racing concepts. It’s the most consistent there is.

@edwin41141

2 жыл бұрын

@@Dorkyand40 thank you my friend

Store seems gone.

@Dorkyand40

Жыл бұрын

he is going through some things currently. check my latest fast on facebook video!