Just got done building one of these. Great video explaining how to build this. And thank you for the quality parts and great customer service. I’ve been very pleased with SWAG Offroad products.

@Swagoffroad

2 жыл бұрын

Glad it is working for you! Don't hesitate to give us a call if there is anything we can help you with!

Thank you for being what helps my shop survive

Another great product! Thanks Troy!

Awesome idea. Stored this for future reference.

Very cool....

What is the operation when you run the bender to the first stop and need to rotate back to pick up the second/third/etc holes on the die? Does the angle finder not rotate back to 0? Mental math at that point, adding the new bend angle to the previous angle? Or, do you release the friction knob, rotate the arm back, then re-engage the friction knob? Either way, it seems like some inaccuracy will be introduced.

@fabannexd868

4 жыл бұрын

I think you would just be looking for the difference. As in if you need to reset your pin at 37deg and your looking to get to 45deg, you would just be looking to add 8deg. Lets say after moving the pin, the DRO reads 5.6 you would add 8 to 5.6 = 13.6...which is truly 45deg from your original 0. I'll find out soon enough if this assumption works after ordering it...

@Swagoffroad

4 жыл бұрын

You only have to zero out your readout once, and the only time you release the friction knob is when you are swapping out dies. No mental math is needed, the readout keeps track of each bend that you make.

Is there a pin for the smaller dies ??

Works great!!! But, I would strongly recommend fitting on the bender before soldering. My install was backward to the clamp and had to disassemble and cut wires to reorient the clamp. Only recommendation: throw three of these in the kit and avoid the soldering hassle. www.mcmaster.com/7056k23

@Rhino2683

4 жыл бұрын

Troy McConaughey z