Suzuki Bandit GSF 1200 N - Carbs Cleaning and Troubleshooting (HD)

Автокөліктер мен көлік құралдары

The year before the carbs were cleaned, motorbike was running, then the winter passed and they are clogged again. The bike can start, but runs only on choke and not very well. So we had to take the carbs out, clean them up, install and look if they cooperate. Of course not all of them did, so we needed to work on them again... and then synchronise them...
TOOLS
- cross and flat long screw drivers
- small and medium flat screw driver
- cleaning brush
- tiny metal wires ment for jets cleaning
- measuring tool for fuel height
- gloves
- fresh air (gasoline smells badly and intense...)
- compressed air is also good, but not necessary
- thermometer to measure exhaust temp
- glass spark plug to see inside the cylinder
MATERIAL
- paper towels
- carb or brake cleaner
- carb repair set with pintle valve, idle screws and float chamber sealing, if something goeas bad
- NBR O-rings for the pintle valve, needle jet, diaphgram chamber and idle screw, the normal ISO ones doesn't fit very good, I would maybe use some for air condition or so as they have other dimensions, or OEM, if you like to
OTHER USEFULL VIDEOS:
SUZUKI Bandit 1200
- Engine Oil Change: • Suzuki Bandit GSF 1200...
- Valve Clearances Adjustment: • Suzuki Bandit GSF 1200...
- Carbs to Engine Mount: • Suzuki Bandit GSF 1200...
- Carbs Cleaning: • Suzuki Bandit GSF 1200...
SUZUKI GS 500 F
- Pulling Engine Out of Frame: • SUZUKI GS 500 F - Engi...
- Disassembly of the Original Engine: • SUZUKI GS 500 F - Engi...
YAMAHA Wild Star 1600
- Engine Resurrection Part 1: • Yamaha XV 1600 Wild St...
- Engine Resurrection Part 2: • Yamaha XV 1600 Wild St...
JAWA 350/639
- Original Dashboard Assembly: • Jawa 350/639 - Origina...
- Carburettor Fuel Height Reset: • Mitsubishi Colt 1.1i -...
- Engine Assembling Part 1 : • Jawa 350/639 engine mo...
- Engine Assembling Part 2 : • Jawa 350/639 final eng...
- Speedometer Gauge Repair: • Jawa 350/639 - Speedom...
MITSUBISHI COLT 1.1 2005
- End Silencer Swap: • Mitsubishi Colt 1.1i -...
- Sway Bar Link Swap: • Mitsubishi Colt 1.1i -...
- Hand Brake Lever Travel Adjustment: • Mitsubishi Colt 1.1i -...
- Drum Brake Repair: • Mitsubishi Colt 1.1i -...
- Quick Pollen Filter Change: • Mitsubishi Colt 1.1i -...
- Oil and Filter Change: • Mitsubishi Colt 1.1i E...
- Water Pump Replacement: • Mitsubishi Colt 1.1i W...
- Alternator Replacement: • Mitsubishi Colt 1.1i -...
- Rear Shock Absorbers Change: • Mitsubishi Colt 1.1i -...
- Headlight Change: • Mitsubishi Colt 1.1i H...
- Air Filter Change: • Mitsubishi Colt 1.1i A...
- Spark Plugs Change: • Mitsubishi Colt 1.1i S...
- Pollen Filter Change: • Mitsubishi Colt 1.1i -...
HYUNDAI i20 2019
- Gearbox Swap: • Hyundai i20 1.2i - Gea...
- Gearbox Sealing Ring Swap: • Hyundai i20 - Gearbox ...
- Skid Plate Repair: / dmplate Repair
BMW E39 2003
- Rear Doors Blocked Inside and Outside - Accessing Door Lock: • BMW e39 - Rear Right D...
- Flywheel and Clutch Replacement: • BMW e39 - Dual to Sing...
- Wiper Arm Fail and Repair: • BMW e39 - Windshield W...
- Front Brake Disc Replacement: • BMW e39 - Front Brake ...
- Engine Oil Change: • BMW e39 520d - Engine ...
- Air filter Change: • BMW e39 520d - Air Fil...
CHEVROLET KALOS
- Control Arm and Top Strut Mount Swap: • Control Arm Bushing & ...
- Brake Caliper Rebuild: • Basic Brake Caliper Re...
- Clutch Swap: • Clutch Swap at Home (HD)
- Sill Rust Repair: • First Time Ever - Hand...
- Half Axle Swap: • Half Axle Swap on a Mc...
- Brake Rotor Refurbishment: • Rusted Brake Rotor Ref...
- Headlight Restoration: • Headlight Restoration ...
- Tie Rod End Swap: • Tie Rod End Swap - Dae...
- Exhaust Center Pipe Swap: • Exhaust Center Pipe Sw...
#motorcyclevideos
#motorcyclerepairing
#motorcyclerestoration
#motorcyclerepair
#motorcyclemaintenance
#motorcycleromance
#suzuki
#suzukibandit

Пікірлер: 8

  • @koyval22
    @koyval2219 күн бұрын

    Wow after some time. A new carb cleaning for a bandit! ❤

  • @REBUILDLab

    @REBUILDLab

    19 күн бұрын

    Not that I was looking for it 😁 Just wanted to ride...

  • @Bandit19990
    @Bandit199909 күн бұрын

    Props for showing that its not always just clean them and it runs great. I've had mine off 3 times before I got it running right, a/f still needs some fettling at tickover.

  • @REBUILDLab

    @REBUILDLab

    9 күн бұрын

    Yes, it's not that easy. I had to set the air fiel mixture after all this was done, to get the bike running right. Of course, because it was all disassembled...

  • @scotsiain1970
    @scotsiain197017 күн бұрын

    Pain in the a$$ bandits. Never had a decent running one yet. 😅

  • @REBUILDLab

    @REBUILDLab

    17 күн бұрын

    Really? Think it can be because of air fuel mixture after carb cleaning. Will post that too...

  • @ThePahan007
    @ThePahan00720 күн бұрын

  • @REBUILDLab

    @REBUILDLab

    20 күн бұрын

    👋

Келесі