Sur Ron Light Bee Primary Belt Drive Replacement Part 2 - Swingarm Install
In this video it's time to install the new belt and put the swingarm back on. This is the most difficult part of the install by the way...
Torques:
Swingarm Axle = 26 ft-lbs
Shock Linkage = 22 ft-lbs
Want to learn how to change the counter sprocket? Check this video out:
• Sur Ron Light Bee Seco...
Want to learn how to make your own swingarm nut tool? Check this video out:
• Sur Ron Light Bee Swin...
Want to learn more about Sur Ron Belts? Check this video out:
• Sur Ron Light Bee Prim...
Пікірлер: 6
You are awesome!
Awesome video! Been trying to reassemble my rear swingarm for the last 2 hours....So I stripped my axlebolt when trying to remove the specialty nut. From the looks of it, I will need to replace as you needed to hold in place with a 5mm allen while torquing down the specialty nut. Would you agree? Do you know where to source the axle bolt? Ebikezilla is out of stock.
@hadesomegamoto7639
3 жыл бұрын
Did you use a special socket? I was afraid of stripping the axle head if I use that to remove or torque the bolt
@travishargrave1102
3 жыл бұрын
@@hadesomegamoto7639 nope :( used needle nose pliers and a crescent wrench to hold. then stripped the hex side as none of my allens fit properly
Tip to others: Use to much grease to hold the spacers in.
@hadesomegamoto7639
3 жыл бұрын
good to know =)