Thanks my brother! It was very useful :) regards from Chile 🇨🇱 and God bless you in your project.

Many thanks

Excellent video... I like your "overlay" of each step in the wiring process. Makes sense to me. Thank you. I am new to the field and wondering if the same wiring diagram can be applied with a 24 V AC supply voltage? Hot 24 V line replacing +24 VDC, and 24 V neutral replacing 0 VDC? We are looking at a Siemens 3RW4036-1BB05 motor starter.

Good job

perfect

thanks

Good day to you I've been watching a handful of your videos and they're pretty good demonstrations I have been meeting my head against the wall trying to figure out wiring on an old motor it's a bodine motor 6 wires too blue to black and two Brown it says to run a 10 microfarad cap on the plate but no diagram the brown wires .5 ohms the black wires 8 ohms the blue wires 18 ohms. Single phase 115 volt. I'm not sure what the 0.5 ohm wires are for

Can I use the wiring diagram for the 24V 3RW40 soft starter or does it have changes

،GOOD

I have a question: a few words, the terminal A1 and A2, always must be energized? The terminal that gives the signal of startup in the circuit is the IN? Thanks brother.

Hi, are you still making videos?

active traduccion automatica a sus videos gracias

Hi . Can use soft starter with 220v single phase ?

How would you connect the motor up? If its in delta?

Please make a video on how to read a circuit diagram of closing and tripping circuit of breaker like L&T ACB, siemens,alstrom,areva VCB.plz reply me

relay duelco nst 2002.2 user manual.help me!

Qual e o nome da música?

Sir I do this . But it's trip automatically

Device and bypass indicator blinkong what is the issue

@AboutElectricity

5 ай бұрын

You need to look at the manual.Should be error codes there.

Sir plz provide point names on this video

off switch 2 no wire where going ???? video rejulation very poor

@hanhlang6329

3 жыл бұрын

Very easy

@hanhlang6329

3 жыл бұрын

I don't know it(relay duelco nst 2002.2 user manual).help me!

This wiring is wrong, why I say that. Because one phase is always live.

@AboutElectricity

Жыл бұрын

Why is that? Give us more details so we can discuss it.