No video
Rebuilding a Carburetor- Autolite 2100 like new!
Mustang wouldn’t start and figured the carb needed a good cleaning and rebuild. Follow along as I take apart the Autolite 2100, clean it and place it back together with new gaskets and parts.
Mustang wouldn’t start and figured the carb needed a good cleaning and rebuild. Follow along as I take apart the Autolite 2100, clean it and place it back together with new gaskets and parts.
Пікірлер: 17
Thank you. This helped a lot - plus, nice job!
@whatsdadcookin6320
4 ай бұрын
Aweosme!! Glad it helped!
thanks. burned my brain for 2 hours before i watched this.. forgot to clip back the float. kept flooding the carb. 😅
@whatsdadcookin6320
Жыл бұрын
Glad it could help!!
Brass float,oe from the factory,the plastic floats are much better,its needn a clean and new parts npieces,my dad modified the brass tubes a little bigger holes,which meant better performence on all the pieces,esp at w.o.t.ohh the power valve is shot ita a mess good luck
how much shaft play is too much and will cause a vacum leak? his sounds pretty tight and squeaky
do you need to plug the hole in the front center of the carb top? mine was spraying out fuel so plugged it with red RTV.
@whatsdadcookin6320
4 ай бұрын
Hmm. Haven’t had issues yet.
Forget the small 2 hole choke assembly gasket?
I had a 1971 2100 rebuilt. When I installed it I found out where the fuel filter goes in is stipped. Is that a pipe thread or do you have any ideas how to repair. Thanks
@whatsdadcookin6320
Жыл бұрын
I’m not sure. Mine was threaded
@Jimmyz96
11 ай бұрын
if i were you , id JB weld a threaded fitting in and use a nipple and an inline filter. once its cured JB is impervious to gasoline
need to tune it still
gaskets for the jets?
@288gto7
13 күн бұрын
He put them on in the video
@Barret_Radtke
13 күн бұрын
@@288gto7 i was asking cause i have never used gaskets for the jets.
WHO WAS AT THE DOOR?