RB26 FULL ENGINE BUILD: Episode 16 - Setting Camshaft Degree & Timing Belt Tension
Welcome to episode 16! In this episode Colton dives into setting the tension of the timing belt, as well as all the steps to properly set the degrees if the intake and exhaust camshaft according to the Kelford specs.
www.boostfactory.ca // Instagram: @boost.factory
Пікірлер: 7
It's always nice when your ATI damper can be used as a degree wheel. Once again, great content guys!
Cam degree seems to be a little painstaking
@boost.factory
18 күн бұрын
yes it can be a bit lengthy, alternative method... adjust on dyno, if adds power good, if not remove!
Info: good Mic: bad
@boost.factory
4 ай бұрын
Oh we know.... mic location sweater pocket = never again!!
Japanese engine, American measurements. Very confusing
@boost.factory
4 ай бұрын
Unfortunately, we are taught imperial and meteic here. And I speak in imperial in the industry out here!