your doing a great job man. you where the one who got me started on VB and im happy to say i have one of the first !!!! and still working really good. happy to see your doing good

@ArmouryEnterprises

3 жыл бұрын

I Kyu! It makes me happy to hear your system is still running! How is the nozzle holding up?

@kyusong3201

3 жыл бұрын

@@ArmouryEnterprises oh its doing good. i stop using steel parts and only use it for aluminum because i was getting rust from the small parts of steel from cleaning steel parts. i used your nozzle and then swap it out. but im back to yours again it just works better. i like the new type you have the 3d print .

Дружище, ты молодец. Просто красава. Все получиться. Отличное исполнение. Благодарю тебя за труд и твое время)))

@ArmouryEnterprises

3 жыл бұрын

Спасибо за комментарий!))

Im keen to learn more about the compressor engine. Interesting.

@ArmouryEnterprises

3 жыл бұрын

kzread.info/dash/bejne/fqlruaqFZ8--k6w.html

Hi Josh, I hope you are keeping well and busy. Over the course of this year I have built up a decent powder coating facility to support the restoration of an old MGTF Replica. I have a fully modified blasting cabinet (dry) and a 10-12 CFM compressor that runs very well at 40PSI to the cabinet. I always intended to change the gun but was surprised that it worked so I have just been using it and it has been performing quite well to be fair. I now need to use the facility I have created to do much more work so I now need a better gun, I also had a problem yesterday with poor media flow through the gun. I subscribe to your channel and have looked through some of you other videos on the guns you have made. Are you still making these and if so where can i go to find out the price? Kind regards Paul (UK)

@ArmouryEnterprises

2 жыл бұрын

Hi Paul, Thanks for the message, you can see all my products here: www.armouryenterprises.com/collections/all I am out of stock at the moment, but you can flick me a message on the email in the video description. I will put you on the list for the next batch. Cheers Josh

nice to see you josh ! is there a solotion for recycling glass beads?

@ArmouryEnterprises

3 жыл бұрын

Hi Nacim, I dry and sieve out my media to use later in my dry cabinet. Once it is dust either in my extractor or spilled on the floor, it just gets swept up and put in the dust bin. Before drying I rinse in with dish soap to seperate the grime and oil in the slurry and then that gets dropped at out local waste oil recovery pick up point.

@cimogt7857

3 жыл бұрын

@@ArmouryEnterprises thank you Josh I will try your method 🙏🙏

How do I contact you about a VB cabinet?

@ArmouryEnterprises

3 жыл бұрын

Hi Tony, Best best is to send me an email on the address I have just added in the video description. Cheers