Good video on my om314 filter there is also new rubber seal in the gap I like to change usually supplied with new filter

@frank-ivo-schulz

2 жыл бұрын

Yes normally there is ni extra rubber seal with the mentioned filter. So I put it in without an extra seal. But only with this Diesel filter ....

Einfach Toll

@frank-ivo-schulz

Жыл бұрын

Danke schön 🤗

Toll erklärt 👍👍

@frank-ivo-schulz

Жыл бұрын

Uuuuups - sorry das habe ich erst jetzt gesehen. Manchmal klappt die Benachrichtigung bei KZread nicht so richtig 🥴😖. Danke schön - das freut mich auch nach dieser langen Zeit ✌️🤠

Cool was sie alles können

@frank-ivo-schulz

2 жыл бұрын

Danke Steven 🤩🙏 das musst Du auch probieren. Einfach aufschrauben und schauen, wie es aussieht. Bekommt man meistens auch wieder zusammen. Was macht Dein Schulbusprojekt - ist das immer noch Dein Traum❓

Daumen hoch

@frank-ivo-schulz

2 жыл бұрын

👍👍😊😊 Danke schön 🤩 ✌️👋

just as black as mine old filter on the OM352 :-) how old was this filter? and thanks for this quality video, never knew there was a handpump to pump the diesel back in / or to pump oxygen out.

@frank-ivo-schulz

2 жыл бұрын

Thank you very much 🙏😍 for your nice comment 👌 That gives me the power to make more videos like this 💪💪 The filter was for about 10000km in that engine. Nice greetings Frank 😊👋

There is a 10mm bleed. But on side of main pump loosening the nut lets air out fast when hand pumping

@frank-ivo-schulz

2 жыл бұрын

Thank you for this helpful additional information 👌👍🤠✌️

@ZerHour

2 жыл бұрын

@@frank-ivo-schulz yes looking at big pump from inside the nut is on right towards the back at an angle its 10'mm screw undo few turns to bleed

@frank-ivo-schulz

2 жыл бұрын

@@ZerHour very good, I will check this when changing the Diesel filter the next time ✌️🤠

@TimmoVerlaan

Жыл бұрын

The video is excellent! Unfortunately my pump seems to not work, at least it doesn't feel like I'm pumping anything. How do I locate the bleed nut? Or how do I get my engine running without the pump?

@ZerHour

Жыл бұрын

@@TimmoVerlaan the bleed nut is 10mm nut you can see it from inside engine /cover off its on the injection pump about 2 o'clock position looking from inside cab its near the back / top 20clock position of big green injection pump on the right of engine above the primer pump , loosen it a turn or so and pump till fuel flows