Thanks George, many of the problems I've had with my x485 I could never have solved without your clear and thoughtful demonstrations, you have saved me lots of frustration and money!

@gotdeeres

Жыл бұрын

Glad it helped

It's always fun to watch someone work on the same model tractor that you have :). Thanks for sharing George

@gotdeeres

2 жыл бұрын

Glad you enjoyed it. I will be adding more videos when I can.

Thanks for sharing all this information! Never would've known that it was O ring 113.

@gotdeeres

4 ай бұрын

JD parts used to actually list the o ring size in the description. I am sure they changed it so you could have 5 times more.

Thanks ☺️

@gotdeeres

2 жыл бұрын

Glad it was helpful.

Great video!!

@gotdeeres

Жыл бұрын

Thanks!

Great video. I think I damaged the internal o-ring on one of my implement quick connects on my 99 powerking. Never changed one, but seems very similar. Thanks!

@gotdeeres

3 жыл бұрын

Most garden tractor use the Pioneer 4000 series hyd couplers so they should be the same.

Have you ever Disassembled a scv, like to see that!

Hello George,, have you made a video yet about the Instrument Cluster? I am having the very same problems as you have , Fuel Gauge and Temp Gauge, not working, great information I enjoy your vids,

@gotdeeres

3 жыл бұрын

Not yet, but i do plan doing one.

My father just handed over his x575 to me. I have two issues to figure out. When idling it’s pulsing but if I slide the choke up some it smooths out. Can you do a video of the Governor spring you mentioned? Wondering if that could be my issue. Also, can you raise and lower the mower the deck when the x45 bucket is attached? I can’t figure out how to raise and lower the deck with the bucket on this thing. Sorry if that’s a dumb question, never owned one of these things and I want to try and restore some of the things on this tractor! Thank you!!

@gotdeeres

2 жыл бұрын

The carburetor problem sounds like to needs be cleaned. Before removing to clean, I would try so Seafoam in the gas before removing the carb. The rockshaft cylinder to raise and lower the deck, uses the same hydraulic circuit as the loader curl. When you connect the loader hydraulics, it is in parallel with the rockshaft cylinder. You have to disconnect the loader curl to use the rockshaft cylinder. There is normally a rockshaft lockout valve installed on the hydraulic valve to block flow when using a loader. You could install a lockout valve on the loader curl line so the rockshaft would work. It would be a manual solution to the problem. I did on one of my loaders.

On the scv, (Up/Down Float Spool Assembly) Mine is hard to move!

@gotdeeres

Жыл бұрын

The lever for the rockshaft/mower is used all of the time. The UP/Down Float is only used with a loader or front blade etc. This valve can be stuck from not being used. Take a hammer and try taping the rod into the valve and pull it out a few times. You may also need to remove the end cap and clean the detent balls. Spray it down with a LOT of penetrating oil like Kroil.

Are you sure "908" is the right number for that O-ring??? Nobody has that number

@gotdeeres

2 жыл бұрын

908 is correct. I ordered them off eBay. The complete description is "AS568-908 RR787 O Ring 75 Duro Black FMK." I have a bag of them in my hand.