Hey you guys are awesome! You make it look easy. I've been doing PPF for about 6 years now and your knowledge has helped me many times. I had a Rubicon 392 today and man your technique helped alot. Thanks guys! Keep up the amazing work.

PERFECT TIMING! I just happened to have a jeep in my shop today!!! :D thanks!!

So useful. Thank you. Greetings from Bulgaria :)

Continue to post I really appreciate it you’re information Thank you so much!!

High high quality instruction!! Thanks boss!!!

I really appreciate the time and detail spent on explaining your techniques. If you happen to have a 2020-2022 Shelby GT500 come through the shop, I would very much appreciate seeing how you tackle that full front kit. I struggle with these!

@PaintProtectionFilmAcademy

2 жыл бұрын

Will do. We’ve done a few. Sometimes time isn’t on my side.

Awesome

Love the videos you put out

@PaintProtectionFilmAcademy

2 жыл бұрын

Thanks for watching.

What brand wrap is that? Thx great video!

🔥🔥🔥🔥

What do you use for your tack spray?

Awesome video. Thank you for the videos! Are you using Reaction or Ultra? What slip solution and ratio are you using?

@PaintProtectionFilmAcademy

2 жыл бұрын

We’re using Reaction. Our 3 gall keg’s have 1/2 oz of Joy Ultra soap for slip.

How much does it cost to do ajeep jlu?

Ron what are your thoughts on using a gel slip?

@PaintProtectionFilmAcademy

2 жыл бұрын

In some case it’s a great tool. I’m not a fan of the cleanup or the fact that it can stain plastic trim pieces.

GELL !!!!!

@PaintProtectionFilmAcademy

2 жыл бұрын

He’ll is awesome. I just don’t like the cleanup afterwards.

Any reason Why you didnt remove the 4 hex bolts and ppfed the under side??? I think it would hold the ppf and cut down the install time in half

@PaintProtectionFilmAcademy

Жыл бұрын

Doing this would break the paint and most likely chip the paint in the bolts. Also the expansion and contraction of the metal would move the film creating a bubble around the bracket

How can i contact you brother

Heeeeyyyy!!!

How did you remove the parts??

@PaintProtectionFilmAcademy

2 жыл бұрын

Under the hood is 4 10mm nuts The latches on the fenders are 13mm

are you using gel

@PaintProtectionFilmAcademy

2 ай бұрын

We use soap and water for our slip.

подвороты не показали как сделали

Yall gonna trim the letters

@PaintProtectionFilmAcademy

2 жыл бұрын

The customer was fine with them being covered. We let it sit in the sun for a bit. Then pressed the edges and used an insulin needle to help evacuate remaining air and moisture

7:55 How do u know u r not going to blade panel?

@PaintProtectionFilmAcademy

Жыл бұрын

It takes practice. Always snapping a fresh blade, controlling the amount of force and just the feel of it. We also try and cut off the car or in panel gaps as much as possible