Jeep TJ Loose Clutch Pedal(Clutch Master and Slave Cylinder Replacement)
Finding out why my clutch pedal is sloppy loose
Master and Slave sealed Unint: amzn.to/3r8U7GX
Clutch spacer file. drive.google.com/file/d/1qdV3...
I am a member of Amazon Associates. Clicking the links is a great way to support my channel. Anything purchased through the links will give me a small commission and cost you nothing. Thanks
Пікірлер: 32
Master and Slave sealed Unint:
Dude thank you so much for doing this video, this literally happened to me tonight and I had to Jerry rig it back in to limp home. I'm gonna grab a new master and slave tomorrow and fix it up!
I'm converting my old ZJ to manual. This has been immensely helpful. Thank you!
Nice video! Just got finished performing this replacement on my TJ. The white retaining straps on the slave cylinder are normally designed to remain in place during the install. The first time you depress the clutch pedal the straps will snap loose & you go back down to the slave cylinder & simply remove the two pieces from the back side of the slave. 😊
Great Video!
I just bought a 2004 TJ and the clutch pedal dropped to the floor. I looked down and the push rod had fallen out. I drove it home with no clutch. Going to fix it tomorrow. Hoping I don't have to replace the master cylinder. Thanks for the video.
Great vid! Getting those camera angles is no easy task. I’d assumed changing that out would be way harder and messier. Thanks for showing how it’s done, and Previous Owner FTW! Who’d a thunk it?
thank you very much, very helpful information
Nice job 👏
nice quick fix for an annoying issue 👍🏻
Did that cylinder come filled and no bleeding needed? If so that is worth what ever they charge.
My clutch doesn’t do that but has a squeaking noise when pressed down. Only starts after driving for 30 minutes or so. Any ideas on what could be the cause?
Do you happen to know the size of that receiver hitch pin? My pedal keeps falling off of my new clutch slave cylinder and I need a fix lol
My clutch has become stiffer over time any ideas? I think imma finally find some down time and replace it
Can you send me one of those 3d printed parts!!??